Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Bigwormgraphix
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 415
Search took 0.03 seconds.
Search: Posts Made By: AlanRubin
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-09-2021, 05:57 AM
Replies: 9
Views: 791
Posted By AlanRubin
The 2010 Camaro V6 nickel and dimes me to death,...

The 2010 Camaro V6 nickel and dimes me to death, but it's a work vehicle
for me. The later model G6 and that 2015 Caddy will all be updated, so yeah,
they're more reliable engine wise. I have...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-08-2021, 07:50 PM
Replies: 9
Views: 791
Posted By AlanRubin
That's if the boot went, he didn't mention that...

That's if the boot went, he didn't mention that at all, just said he thinks
a CV joint broke. When I had that one break on me, there was no grease flung
anywhere, the boot didn't break...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 11-08-2021, 07:45 PM
Replies: 2
Views: 262
Posted By AlanRubin
The 12V lighter socket & power one in the console...

The 12V lighter socket & power one in the console are only on when the ignition is on,
with the key... Should also be on when the remote starter is active, since you are
using the same ignition...
Forum: General Automotive + Other Cars Discussion 11-08-2021, 02:36 AM
Replies: 8
Views: 2,187
Posted By AlanRubin
Not what the articles are saying, so whatever...

Not what the articles are saying, so whatever Skippy...
Forum: Suspension / Brakes / Chassis 11-08-2021, 02:33 AM
Replies: 4
Views: 461
Posted By AlanRubin
Don't see how it's hard to tighten the bolts, or...

Don't see how it's hard to tighten the bolts, or the anchor bolts, I go 80 ft-lbs on all
my cars. Caliper slide pin bolts, 23-25 ft-lbs, and done. I don't do the XXX-degree
turns ever. NEVER...
Forum: Cosmetics and Lighting Modification Discussions 11-08-2021, 02:27 AM
Replies: 5
Views: 616
Posted By AlanRubin
Happens up front too, so I bolted mine on. I...

Happens up front too, so I bolted mine on. I used real small Stainless Steel domed hex
head fasteners.
Forum: Suspension / Brakes / Chassis 11-07-2021, 02:43 AM
Replies: 4
Views: 461
Posted By AlanRubin
Arrows face the direction of the wheel rotation. ...

Arrows face the direction of the wheel rotation.

https://www.bremboparts.com/europe/en/support/fitting-and-maintenance/directional-brake-pads-138418
Forum: 5th Gen Camaro SS LS LT General Discussions 11-07-2021, 02:33 AM
Replies: 15
Views: 1,206
Posted By AlanRubin
Assuming you mean LONG TUBE headers, then all the...

Assuming you mean LONG TUBE headers, then all the stuff ^HE said...

Shorties, nothing.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-07-2021, 02:23 AM
Replies: 9
Views: 791
Posted By AlanRubin
What do you mean by Standard rear Diff? They're...

What do you mean by Standard rear Diff? They're OPEN diffs, not LSD, so yeah
If a CV joint tore, the car would not move, because of the open differential.
The broken axle side would spin, it would...
Forum: Suspension / Brakes / Chassis 11-07-2021, 02:11 AM
Replies: 10
Views: 683
Posted By AlanRubin
I used the Whiteline, and could feel the...

I used the Whiteline, and could feel the difference right away.

The inserts not only tighten the up and downward movement, but also tightens
up the lateral movement.
Forum: General Automotive + Other Cars Discussion 11-06-2021, 01:00 AM
Replies: 8
Views: 2,187
Posted By AlanRubin
In order to get cars on the road, they have to...

In order to get cars on the road, they have to skip some features, DUE to the
chip shortage. I don't know how Nintendo keeps hemorrhaging consoles, when
there is a chip shortage. You can buy a...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-03-2021, 02:51 AM
Replies: 29
Views: 2,058
Posted By AlanRubin
I have had actual solenoid issues, and "D" never...

I have had actual solenoid issues, and "D" never blinked on me.
They're intermittent...

The GM Manual says the D on the dash will flash if a trouble code is being entered to
the Transmission...
Forum: Transmission / Driveline 11-03-2021, 02:43 AM
Replies: 13
Views: 1,400
Posted By AlanRubin
It CLEARLY shows a list of AVAILABLE gear sets...

It CLEARLY shows a list of AVAILABLE gear sets...
Forum: Tuning / Diagnostics -- engine and transmission 11-03-2021, 02:42 AM
Replies: 4
Views: 435
Posted By AlanRubin
There is no P0228C code. It is either P228C...

There is no P0228C code.

It is either P228C or P0228.

P228C Fuel Pressure Regulator 1 Exceeded Control Limits - Pressure Too Low
-or-
P0228 Throttle Position Sensor/Switch C Circuit High Input
Forum: Suspension / Chassis / Brakes 11-03-2021, 02:35 AM
Replies: 4
Views: 470
Posted By AlanRubin
https://www.facebook.com/marketplace/item/16184450...

https://www.facebook.com/marketplace/item/1618445098351552

Yeah, more information helps...

I have a pair of stock ones in my shed... I was told they have 17,000 miles
on them. I got them...
Forum: Cosmetics and Lighting Modification Discussions 11-03-2021, 02:32 AM
Replies: 7
Views: 629
Posted By AlanRubin
eBay, all day...

eBay, all day...
Forum: 5th Gen Camaro SS LS LT General Discussions 11-03-2021, 02:31 AM
Replies: 11
Views: 1,064
Posted By AlanRubin
These cars have high-speed and low-speed CAN. ...

These cars have high-speed and low-speed CAN.

The high speed GM LAN bus is terminated with a pair of 120 ohm resistors. One line
is driven high (3.5 volts) while the other data line is...
Forum: 5th Gen Camaro SS LS LT General Discussions 11-03-2021, 02:17 AM
Replies: 2
Views: 567
Posted By AlanRubin
There is no transmitter, you mean the receiver. ...

There is no transmitter, you mean the receiver. The transmitter is located inside
the Key FOB.

10-15 Camaro Keyless Entry-Receiver for Key Fob Remote 13503204...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-31-2021, 01:16 AM
Replies: 5
Views: 621
Posted By AlanRubin
It lines up with the trans tail-shaft flange. ...

It lines up with the trans tail-shaft flange.

The "Y" portion of the shaft matches the rear, so if you are looking at the
trans tail, and see "Y", then it will be the same at the differential. ...
Forum: Camaro DIY & HOW-TO instructions & discussions 10-27-2021, 03:40 AM
Replies: 7
Views: 657
Posted By AlanRubin
The Oils we have at the shop actually have an...

The Oils we have at the shop actually have an expiration date on them.
From the date of manufacturing:
Mobile says 5-years.
Total says 2-Years.
Valvoline motor oils do not have documented...
Forum: 5th Gen Camaro SS LS LT General Discussions 10-26-2021, 08:00 AM
Replies: 10
Views: 1,214
Posted By AlanRubin
I Am on my 3rd one, flagged the stabilitrack, and...

I Am on my 3rd one, flagged the stabilitrack, and displayed REDUCED
POWER MODE !


Never got a stablilitrack error for misfires, and I had them for a while, till I
fixed the problem.
Forum: 5th Gen Camaro SS LS LT General Discussions 10-26-2021, 07:56 AM
Replies: 1
Views: 306
Posted By AlanRubin
Seals are installed with a tool. 16 lb ft...

Seals are installed with a tool.

16 lb ft for the bolt.
Forum: 5th Gen Camaro SS LS LT General Discussions 10-26-2021, 07:38 AM
Replies: 2
Views: 303
Posted By AlanRubin
Most of the time, the radios are installed...

Most of the time, the radios are installed (wired) incorrectly.

You need to do a current draw test, and pull fuses one at a time, to see when the
load drops. You pull the fuse, look at the...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 10-25-2021, 04:14 AM
Replies: 1
Views: 306
Posted By AlanRubin
Flywheel/Flex Plate/Drive Plate Torque: First...

Flywheel/Flex Plate/Drive Plate Torque:
First Pass 20 N.m (15 lb ft)
Second Pass 50 N.m (37 lb ft)
Final Pass 100 N.m (74 lb ft)

Clutch Pressure Plate Bolts: 30 N.m / 22 lb ft
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 10-25-2021, 04:04 AM
Replies: 4
Views: 904
Posted By AlanRubin
Bitcoin is at an all time high right now. The...

Bitcoin is at an all time high right now. The time to buy was when it was in the
30,000 range. You would have doubled your investment.

So, if you invested $24,000 when it was 30,000, you'd...
Forum: Forced Induction - V8 10-25-2021, 04:02 AM
Replies: 3
Views: 492
Posted By AlanRubin
Hiflow, not as much as factory cats, so if you...

Hiflow, not as much as factory cats, so if you need cats to pass, then get the Hi-flow.
IF they only need to SEE them, then, as I did, gutted mine. They're there, but there
is nothing in them.
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 10-23-2021, 05:18 PM
Replies: 6
Views: 630
Posted By AlanRubin
Some differentials also have doughnut magnets on...

Some differentials also have doughnut magnets on the back inside of the back cover
plate. They're not a HARD magnet, they are like a soft rubber magnet, so that
if it falls off, it won't tear up...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-23-2021, 05:11 PM
Replies: 3
Views: 332
Posted By AlanRubin
Send it...

Send it...
Forum: Suspension / Brakes / Chassis 10-23-2021, 05:00 PM
Replies: 20
Views: 1,130
Posted By AlanRubin
You can do it on ramps, and it will keep the...

You can do it on ramps, and it will keep the wheel in place, so it does not
shift on you when you pull the LCA down and out of the bracket. I do
most of my work on ramps. When on a lift, and you...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 10-23-2021, 04:49 PM
Replies: 3
Views: 531
Posted By AlanRubin
I like more rear sound, with front blend. The...

I like more rear sound, with front blend. The door speakers are just too low for proper
spatial sound. With good tweeters in the door sails, you can raise it some, but you may
need to lower the...
Showing results 1 to 30 of 415

 
Forum Jump

All times are GMT -5. The time now is 04:25 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2022, vBulletin Solutions, Inc.