Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com

		Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Search Results

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: KillboyPowerhead

Forum: Suspension / Brakes / Chassis

08-15-2018, 10:42 AM

Replies: 773

Sticky: Alignment Help Thread

Views: 324,886

Posted By KillboyPowerhead

There are no camber plates available for the rear...

There are no camber plates available for the rear of this car.

There should be no issue getting more than -0.8° negative camber with 1" springs.

I would verify that the install was done...

Forum: Suspension / Brakes / Chassis

10-24-2017, 05:57 AM

Replies: 773

Sticky: Alignment Help Thread

Views: 324,886

Posted By KillboyPowerhead

How much do you care about tire wear? Front...

How much do you care about tire wear?

Front camber: -1.5° for tire wear so that you don't have to keep changing camber for the street; -2.0 to -2.5° if you don't care about tire wear.

Front...

Forum: Suspension / Brakes / Chassis

10-12-2017, 04:09 PM

Replies: 773

Sticky: Alignment Help Thread

Views: 324,886

Posted By KillboyPowerhead

Most if not all cars understeer from the factory...

Most if not all cars understeer from the factory - it's a safety thing - so if your car is stock it will understeer. A square tire setup is a good start; to add to this consider a larger rear sway...

Forum: Suspension / Brakes / Chassis

10-12-2017, 01:24 PM

Replies: 773

Sticky: Alignment Help Thread

Views: 324,886

Posted By KillboyPowerhead

Can you measure tire temps? This would let you...

Can you measure tire temps? This would let you know if you could use more or less camber. What else have you done on the car? Sway bar sizes? Spring rates? Tire sizes?

Forum: Suspension / Brakes / Chassis

09-18-2017, 07:25 PM

Replies: 773

Sticky: Alignment Help Thread

Views: 324,886

Posted By KillboyPowerhead

First step would be to go to a different shop...

First step would be to go to a different shop :nod:. The front camber is adjusted by loosening the two nuts/bolts at the bottom of the strut - one hole is elongated to allow the strut to pivot on the...

Forum: Suspension / Brakes / Chassis

09-15-2017, 05:39 AM

Replies: 773

Sticky: Alignment Help Thread

Views: 324,886

Posted By KillboyPowerhead

Elongating the radius rod bolt hole at the...

Elongating the radius rod bolt hole at the subframe like GM should have done (!), by drilling/grinding it out will allow you to gain more caster - this is not required but if you're getting more into...

Forum: Suspension / Brakes / Chassis

05-17-2017, 11:34 AM

Replies: 773

Sticky: Alignment Help Thread

Views: 324,886

Posted By KillboyPowerhead

Hey! You never told me this! :sad0147:

Hey! You never told me this! :sad0147:

Showing results 1 to 7 of 7

Forum Jump

All times are GMT -5. The time now is 11:26 PM.