Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
dave@hennessey
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 500
Search took 0.05 seconds.
Search: Posts Made By: Badbubba
Forum: Forced Induction - V8 06-15-2018, 08:35 AM
Replies: 3
Views: 110
Posted By Badbubba
I did not like the fuel pressure drop and, even...

I did not like the fuel pressure drop and, even more so, the slow recovery with a small shot. 2010 LS3 with bolt-ons, no cam. May just be my pump, yours may differ.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-12-2018, 09:57 PM
Replies: 27
Views: 1,040
Posted By Badbubba
Very slight improvement, after getting over about...

Very slight improvement, after getting over about 30mph. Remove wheel, pull inner fender out. Used a Dremel tool to cut, tight space to work. Deleted the washer bottle way before installing ADM...
Forum: Forced Induction - V8 06-10-2018, 10:46 PM
Replies: 17
Views: 374
Posted By Badbubba
Allows a pwm pump to catch up.

Allows a pwm pump to catch up.
Forum: Forced Induction - V8 06-10-2018, 10:42 PM
Replies: 17
Views: 374
Posted By Badbubba
If you click on the link on past post, explains.

If you click on the link on past post, explains.
Forum: Forced Induction - V8 06-10-2018, 03:53 PM
Replies: 17
Views: 374
Posted By Badbubba
Yeah, but the programming is different for the...

Yeah, but the programming is different for the pump.
Forum: Forced Induction - V8 06-10-2018, 03:47 PM
Replies: 17
Views: 374
Posted By Badbubba
Log and go with the biggest shot until you can...

Log and go with the biggest shot until you can get the dedicated.
Forum: Forced Induction - V8 06-10-2018, 03:00 AM
Replies: 17
Views: 374
Posted By Badbubba
Start with a 50 or 100 shot and log. Step your...

Start with a 50 or 100 shot and log. Step your way up to the 150. Watch what wideband you get, some only are for straight gas with a 14.7 afr for stoichy. If it can display in lambda, use lambda. ...
Forum: Forced Induction - V8 05-19-2018, 09:52 PM
Replies: 4
Views: 379
Posted By Badbubba
Your controller/window switch will connect to the...

Your controller/window switch will connect to the tps on the tb. You have a rising and falling voltage that you can connect to. This will allow your system to operate only at wot. Your window...
Forum: Cosmetics and Lighting Modification Discussions 04-12-2018, 09:21 AM
Replies: 32
Views: 1,124
Posted By Badbubba
Curt 56089 is what I used and what Curt has...

Curt 56089 is what I used and what Curt has listed for 2010/11. I believe the 2012/13 has a different style wiring harness plug, thus Curt 56363. I'm thinking it was a single 3 ohm 50 watt resistor...
Forum: Cosmetics and Lighting Modification Discussions 04-12-2018, 01:32 AM
Replies: 32
Views: 1,124
Posted By Badbubba
Curt 56253 wiring harness. You'll only use part...

Curt 56253 wiring harness. You'll only use part of harness. It T's into your wiring harness. Then use the wires provided.to add your resistors. 2012/13 is slightly different from my 2010. But...
Forum: Cosmetics and Lighting Modification Discussions 04-11-2018, 03:41 PM
Replies: 32
Views: 1,124
Posted By Badbubba
You should not need a load resistor on the...

You should not need a load resistor on the parking light circuit, only a 6 ohm on the brake/turn side of the bulb. Use a trailer harness for adding the resistors, that way you do not cut into the...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-03-2018, 09:15 AM
Replies: 24
Views: 4,192
Posted By Badbubba
1 crimp bolt on steering shaft, then slides...

1 crimp bolt on steering shaft, then slides apart. Do not let anyone spin the shaft or steering wheel while it is apart.
Forum: 5th Gen Camaro SS LS LT General Discussions 04-02-2018, 01:42 AM
Replies: 7
Views: 462
Posted By Badbubba
Pic of angle gauge? Usually has an arm that...

Pic of angle gauge? Usually has an arm that extends to "lock" it down. Then set the gauge to zero. Was the arm secure?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-25-2018, 01:42 AM
Replies: 20
Views: 1,093
Posted By Badbubba
I've read that the manual cars get alot of wheel...

I've read that the manual cars get alot of wheel hop and axles breaking while using the factory launch control. I got hop wheel hop using launch control. Launch control is used in competitive mode,...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-23-2018, 09:29 AM
Replies: 11
Views: 856
Posted By Badbubba
How was the N2O tuned prior? Getting fuel from...

How was the N2O tuned prior? Getting fuel from the rail? Timing? Plugs? 150 or 200 shot? Maybe it was slightly hurt before the cam install.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-23-2018, 09:17 AM
Replies: 20
Views: 1,093
Posted By Badbubba
What is the risk of wetting down the cylinder...

What is the risk of wetting down the cylinder walls with unburnt fuel by using an ignition cut 2 step?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-23-2018, 09:12 AM
Replies: 20
Views: 1,093
Posted By Badbubba
What components did you use for your 2 step? ...

What components did you use for your 2 step? CTAP? And?
Forum: Forced Induction - V8 03-20-2018, 05:12 PM
Replies: 2
Views: 238
Posted By Badbubba
90 degrees F will get you about 980 psi. With...

90 degrees F will get you about 980 psi. With just a manual switch for the heater, one needs to be mindful about temperature to prevent overheating. Which could lead to a high enough pressure to...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-20-2018, 07:19 AM
Replies: 11
Views: 856
Posted By Badbubba
Did you ever spray before the cam install? If...

Did you ever spray before the cam install? If so, what's your complete N2O setup, jets? 100% sure your bottle valve was shut and sealed off, N2O solenoid closed and the system did not activate? #7...
Forum: Forced Induction - V8 03-13-2018, 03:02 PM
Replies: 9
Views: 485
Posted By Badbubba
Installed a Nitrous Outlet dedicated pump for the...

Installed a Nitrous Outlet dedicated pump for the N2O about a month ago. Roads and weather is still bad.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-12-2018, 02:35 AM
Replies: 27
Views: 1,125
Posted By Badbubba
Imo, lack of oil should show some heating.

Imo, lack of oil should show some heating.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-10-2018, 08:12 PM
Replies: 6
Views: 292
Posted By Badbubba
You flip the tb 180.

You flip the tb 180.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-10-2018, 08:11 PM
Replies: 27
Views: 1,125
Posted By Badbubba
I don't really see a picture of the bottom of the...

I don't really see a picture of the bottom of the bearing. The little I see still has damage. Can you post a pic of the bottom?
Forum: Forced Induction - V8 03-10-2018, 03:46 AM
Replies: 9
Views: 485
Posted By Badbubba
So far I've had no issues using the Nitrous...

So far I've had no issues using the Nitrous Outlet plate system designed for our car. Their customer service is excellent. You will definitely need more fuel if your tapping off the rail and using...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-10-2018, 03:35 AM
Replies: 27
Views: 1,125
Posted By Badbubba
Europe's octane number is derived RON, our's is...

Europe's octane number is derived RON, our's is R+M/2. Research + Measured. Their octane ratings do not equal ours.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-10-2018, 03:27 AM
Replies: 6
Views: 292
Posted By Badbubba
Which plate?

Which plate?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-10-2018, 03:23 AM
Replies: 39
Views: 1,472
Posted By Badbubba
Not to deviate but, electron flow is negative to...

Not to deviate but, electron flow is negative to positive. Conventional flow is positive to negative. Voltage drops and the amount of current are the same with either one.
Forum: Forced Induction - V8 03-08-2018, 04:47 PM
Replies: 18
Views: 1,005
Posted By Badbubba
They usually tune them out.

They usually tune them out.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-08-2018, 04:35 PM
Replies: 39
Views: 1,472
Posted By Badbubba
No ground wire from battery to engine.

No ground wire from battery to engine.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-08-2018, 04:09 PM
Replies: 27
Views: 1,125
Posted By Badbubba
Imo, bearing clearance/fitment. Possible bad...

Imo, bearing clearance/fitment. Possible bad polish on crank. You ran the same setup and fuel prior to these changes with no issues to the rod bearings. Guessing there is no problems with the main...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 08:10 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2018, vBulletin Solutions, Inc.