Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Phastek Performance
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Showing results 1 to 14 of 14
Search took 0.01 seconds. Search: Posts Made By: Babybyler15
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 02-12-2021, 10:20 PM
Replies: 21
Views: 11,674
Posted By Babybyler15
Problem solved! After scrolling through the...

Problem solved!

After scrolling through the camaro maintenance manual I purchased recently, I came across something that struck my attention, it identified the bank 1 o2 sensor was on the same...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 02-11-2021, 02:18 PM
Replies: 21
Views: 11,674
Posted By Babybyler15
Dealership replaced ecm, still no fix. I replaced...

Dealership replaced ecm, still no fix. I replaced the individual wires not the entire wiring harness. Read somewhere that the knock sensor wires need to be shielded, they don’t look shielded but I...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 02-04-2021, 11:14 PM
Replies: 21
Views: 11,674
Posted By Babybyler15
No I always keep the oil in check, I just got a...

No I always keep the oil in check, I just got a gm recommended ACDELCO knock sensor because a mechanic at the dealership said gm doesn’t like aftermarket sensors much, installed it today and still...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 02-04-2021, 11:00 PM
Replies: 21
Views: 11,674
Posted By Babybyler15
No I always keep the oil in check, I just got a...

No I always keep the oil in check, I just got a gm recommended ACDELCO knock sensor because a mechanic at the dealership said gm doesn’t like aftermarket sensors much, installed it today and still...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 01-28-2021, 10:10 PM
Replies: 21
Views: 11,674
Posted By Babybyler15
Funny you say that cause I got the CEL code RIGHT...

Funny you say that cause I got the CEL code RIGHT after doing an oil change, I know it’s too far unlikely for that to be the cause but I never use cheap oil, always double check it’s the right kind...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 01-28-2021, 10:08 PM
Replies: 21
Views: 11,674
Posted By Babybyler15
The symptoms and issues are so big of a spectrum...

The symptoms and issues are so big of a spectrum it’s hard to figure out, it’s either your car’s actually knocking, bad knock sensor, bad wiring, or bad ECM and it just ends there. Hahah. Been going...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 01-28-2021, 12:16 PM
Replies: 21
Views: 11,674
Posted By Babybyler15
I have 104k miles, running premium fuel when this...

I have 104k miles, running premium fuel when this whole thing started to mitigate knock, but I don’t hear any knock the engine runs fine. What’s the best way to do an upper cleaning? Just replaced...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 01-26-2021, 05:22 PM
Replies: 21
Views: 11,674
Posted By Babybyler15
Update: got the wiring harness install, still...

Update: got the wiring harness install, still getting p0325 but p0330 went away, this week I’m gonna try one last time replacing the knock sensor (maybe got a bad one from the store) and if that...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 01-05-2021, 01:52 AM
Replies: 21
Views: 11,674
Posted By Babybyler15
I’m ordering the entire wiring harness from a GM...

I’m ordering the entire wiring harness from a GM parts website, hopefully it doesn’t end up being the ECM although with the stimulus check it’ll be a lil easier
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 12-23-2020, 10:08 PM
Replies: 21
Views: 11,674
Posted By Babybyler15
There’s no way to properly repair the wiring...

There’s no way to properly repair the wiring harness without jeopardizing the integrity and messing up the resistance? I used good butt connectors and heat wrap to make sure it was snug. :bonk:
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 12-21-2020, 04:03 PM
Replies: 21
Views: 11,674
Posted By Babybyler15
Update, I found the two wires going from ECU to...

Update, I found the two wires going from ECU to the bank 2 knock sensor; about 3 inches out i cut the wires and spliced on a pigtail connector and knock sensor to make sure I could see everything was...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 12-17-2020, 05:21 PM
Replies: 21
Views: 11,674
Posted By Babybyler15
@co14camaro how would I go about testing for...

@co14camaro how would I go about testing for breaks with a mulitimeter?
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 12-15-2020, 02:09 PM
Replies: 0
Views: 1,550
Posted By Babybyler15
Knock Sensor Codes; Please Help!

About a month ago I received two codes, P0330, and P06B7. Knock sensor malfunction bank 2 and Knock Sensor Performance Bank Two. I took it to the shop and they replaced both knock sensors, and found...
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 12-14-2020, 11:12 PM
Replies: 21
Views: 11,674
Posted By Babybyler15
KNOCK SENSOR CODES PLEASE HELP

PROBLEM SOLVED! Solution on post #21

About a month ago I received two codes, P0330, and P06B7. Knock sensor malfunction bank 2 and Knock Sensor Performance Bank Two. I took it to the shop and they...
Showing results 1 to 14 of 14

 
Forum Jump

All times are GMT -5. The time now is 04:44 AM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.