Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
dave@hennessey
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Page 1 of 3 1 23
Showing results 1 to 30 of 85
Search took 0.01 seconds. Search: Posts Made By: Luvdamud
Forum: 5th Gen Camaro SS LS LT General Discussions 03-27-2020, 01:37 PM
Replies: 9
Views: 3,154
Posted By Luvdamud
Matthew, follow the advice in the thread above, I...

Matthew, follow the advice in the thread above, I had to do the same thing on my 2010. I also had to put my original 2010 seat belt connectors on to my leather 2012 seats. For some asinine reason,...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-02-2019, 07:59 PM
Replies: 30
Views: 8,834
Posted By Luvdamud
I had a set of Taylor's and cooked them on the...

I had a set of Taylor's and cooked them on the dyno. The glue that ties the boot to the wire would liquify and allow the wire to pull out of the boot. This happened with fans blowing down on both...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-12-2019, 10:44 AM
Replies: 30
Views: 4,400
Posted By Luvdamud
BG, good luck on whatever you choose. My fab...

BG, good luck on whatever you choose. My fab shop guy is a mustang guy, and he has done probably 20+ terminator builds and 10+ Shelby and Mach I builds. He told me he hears this all the time. The...
Forum: Forced Induction - V8 08-03-2019, 09:04 PM
Replies: 32
Views: 4,134
Posted By Luvdamud
Put a 160 in mine. Driving today in 90°+ heat...

Put a 160 in mine. Driving today in 90°+ heat today. Mine seems to like to cruise at 2K and around 40 to 45 mph. It stays between 182-185. Heats up when I am turning less than 2K rpm. Will get up...
Forum: Forced Induction - V8 07-22-2019, 07:34 PM
Replies: 13
Views: 2,142
Posted By Luvdamud
aeroforce defroster vent dual pod and MM catch...

aeroforce defroster vent dual pod and MM catch can on my twin turbo setup too.
Forum: Forced Induction - V8 07-22-2019, 07:29 PM
Replies: 9
Views: 1,602
Posted By Luvdamud
Gunchamp, I had a single Huron setup and was very...

Gunchamp, I had a single Huron setup and was very happy with it. When I broke a ring on #7 piston, I went forged bottom end and traded in my single for a twin. Jon was great to deal with, everything...
Forum: Forced Induction - V8 04-29-2019, 05:48 PM
Replies: 15
Views: 4,724
Posted By Luvdamud
Damn Justin, that looks awesome!

Damn Justin, that looks awesome!
Forum: Wheels / Tires 04-14-2019, 06:31 PM
Replies: 4
Views: 1,094
Posted By Luvdamud
Pm'd

Pm'd
Forum: Forced Induction - V8 03-23-2019, 08:04 PM
Replies: 7
Views: 1,439
Posted By Luvdamud
IKS what kind of fueling are you using? Gonna be...

IKS what kind of fueling are you using? Gonna be hard to hit 800 at the wheels without more fuel. When I had the Huron single kit, I made 632 on a Mustang dyno with stock fuel pump and 1000cc...
Forum: 5th Gen Camaro SS LS LT General Discussions 02-25-2019, 05:36 PM
Replies: 88
Views: 8,446
Posted By Luvdamud
In my 2010 SS, I get asked if it is a V6 at...

In my 2010 SS, I get asked if it is a V6 at stoplights because it is so quiet at idle. I usually just say yes and most people are cool but sometimes people in cars they think are fast smirk and...
Forum: Forced Induction - V8 02-04-2019, 09:52 PM
Replies: 11
Views: 1,778
Posted By Luvdamud
1LE, I used my stock rails and my fab guy tigged...

1LE, I used my stock rails and my fab guy tigged -10 fittings on them. I go pump -> filter -> regulator -> rails. I did -10 feed and -8 return with twin TI pumps. I like the look of the...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 01-09-2019, 08:24 PM
Replies: 5
Views: 1,230
Posted By Luvdamud
Proto, where were you at 2 weeks ago? I just...

Proto, where were you at 2 weeks ago? I just spent $346 on a mighty mouse!!!
That is a good price. Good luck with the sale.
Forum: 5th Gen Camaro SS LS LT General Discussions 01-09-2019, 07:59 PM
Replies: 15
Views: 2,051
Posted By Luvdamud
I removed mine when I did my turbo build. Good...

I removed mine when I did my turbo build. Good riddance. No issues. If I was road racing, I would have probably kept it. Large plug in side of block and a block off plate above the oil filter with...
Forum: 5th Gen Camaro SS LS LT General Discussions 12-31-2018, 08:03 PM
Replies: 3
Views: 889
Posted By Luvdamud
Andrew, I have watched many of your build and...

Andrew, I have watched many of your build and tune videos. You guys have done some great work. I thought about bringing my car to your shop for a drivability tune in the spring. My local guy has...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 12-29-2018, 06:11 PM
Replies: 24
Views: 2,601
Posted By Luvdamud
VB, if you can do all the labor yourself then I...

VB, if you can do all the labor yourself then I would say go for it. The OP is going to pay a shop to do the work. Not nearly as economical. Not to mention swapping it back. I left my clutch pedal...
Forum: Transmission / Driveline 12-29-2018, 09:36 AM
Replies: 9
Views: 906
Posted By Luvdamud
What harness? Are you going to a 4l80e from the...

What harness? Are you going to a 4l80e from the M6? You will need a standalone trans controller for the 4l80e. It should come with the harness. I have not seen any way to adapt the 4l80 to the...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 12-29-2018, 08:57 AM
Replies: 24
Views: 2,601
Posted By Luvdamud
Sell it and buy the auto. I did mine and have...

Sell it and buy the auto. I did mine and have about 6500 in a 4l80e swap. Now it has a very limited market if I want to sell it. If you buy a new auto, you can procharge it, run it for 50k miles,...
Forum: V8 Bolt-Ons & Tunes 09-08-2018, 09:02 PM
Replies: 59
Views: 28,091
Posted By Luvdamud
Juiced, can you PM me a price on a Whipple for...

Juiced, can you PM me a price on a Whipple for the 2018 f150 5.0? I am thinking about adding one of those to the stable.
Forum: Forced Induction 08-06-2018, 06:24 PM
Replies: 1
Views: 426
Posted By Luvdamud
Will you do $80 shipped? If so, pm me and I will...

Will you do $80 shipped? If so, pm me and I will take it. I could use a spare.
Chris
Forum: Wheels / Tires 08-06-2018, 05:58 PM
Replies: 6
Views: 1,321
Posted By Luvdamud
Bump

Bump
Forum: Wheels / Tires 07-20-2018, 03:46 PM
Replies: 6
Views: 1,321
Posted By Luvdamud
XC, I'm in Winchester about 90 minutes from...

XC, I'm in Winchester about 90 minutes from Rockville. Just the rears would be $400 for tires and wheels.
Forum: Wheels / Tires 07-20-2018, 06:26 AM
Replies: 6
Views: 1,321
Posted By Luvdamud
They are in decent shape and yes, I would sell...

They are in decent shape and yes, I would sell just the rears. The wheels need to have the rest of the plasti dip peeled off from them to be certain. It would probably take an hour to remove all...
Forum: Forced Induction 07-18-2018, 08:29 PM
Replies: 3
Views: 853
Posted By Luvdamud
El Boricua, I do still have the under plate but I...

El Boricua, I do still have the under plate but I haven't decided if I am going to use it or not. PM me your email and I will send some pics. The pics are too big and I have to shrink them down to...
Forum: Wheels / Tires 07-18-2018, 08:27 PM
Replies: 6
Views: 1,321
Posted By Luvdamud
2010 SS wheels w/NT 555r drag radials

Guys, I am moving and have a spare set of wheels and tires that I am selling. They are stock wheels off my 2010 SS. Wheels are in very good shape, they were plasti-dipped and still have some...
Forum: Forced Induction 07-17-2018, 10:55 AM
Replies: 3
Views: 853
Posted By Luvdamud
Huron Speed turbo parts

Hey guys, I have a bunch of leftover parts from my Huron Speed twin build if you are interested. I have both turbo intake pipes (new), both air filters that go inside the fenders (new), Intercooler...
Forum: Transmission / Driveline 07-12-2018, 12:57 PM
Replies: 5
Views: 1,858
Posted By Luvdamud
Sorry DDjj, it is long gone..

Sorry DDjj, it is long gone..
Forum: USA - Mid-Atlantic 05-30-2018, 09:41 AM
Replies: 1
Views: 793
Posted By Luvdamud
Twin turbo tuner in NoVA?

Guys, I just put a set of 62/65 Comp Turbo's on my 2010 Camaro with a 4L80 and would love to have a reputable shop tune it for drivability. It is running strong up top it needs some work in the mid...
Forum: Forced Induction - V8 02-24-2018, 05:11 PM
Replies: 43
Views: 12,131
Posted By Luvdamud
94guy, do you daily this car on ms109? I can't...

94guy, do you daily this car on ms109? I can't imagine how much I would spend in fuel just to go cruise.
Forum: Forced Induction 02-21-2018, 08:29 PM
Replies: 16
Views: 17,398
Posted By Luvdamud
Diablo, reach out to Jon at Huron Speed. I know...

Diablo, reach out to Jon at Huron Speed. I know he has a used single kit because I just shipped mine back to him. No issues at all, just going twins from him.
Forum: Camaro 1LE Forum 01-30-2018, 05:19 PM
Replies: 46
Views: 4,139
Posted By Luvdamud
Snowflake

Snowflake
Showing results 1 to 30 of 85
Page 1 of 3 1 23

 
Forum Jump

All times are GMT -5. The time now is 06:36 PM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.