Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Emblempros
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 197
Search took 0.03 seconds.
Search: Posts Made By: Level300
Forum: Local Marketplace 02-16-2020, 10:07 AM
Replies: 0
Views: 45
Posted By Level300
WTB mpd1 cowl hood...

Looking for a mpd1 cowl hood. The regular kind not the copo hood. I can swap you my harwood cowl + cash if you need a hood. Let me know if youíre interested.
Forum: 5th Gen Camaro SS LS LT General Discussions 01-22-2020, 06:57 PM
Replies: 36
Views: 1,245
Posted By Level300
All pointers should be, more or less, pointing...

All pointers should be, more or less, pointing straight up, then you’re good to go. My volts are typically to the right of center, just like yours. Oil pressure sounds like how my oil pressure...
Forum: 5th Gen Camaro SS LS LT General Discussions 01-17-2020, 02:30 PM
Replies: 33
Views: 1,380
Posted By Level300
Don't they have to disclose any accidents? I...

Don't they have to disclose any accidents? I could swear there's some law around that.
Forum: Camaro 1LE Forum 01-12-2020, 01:48 AM
Replies: 7
Views: 660
Posted By Level300
That’s why I drive with my npp mostly open. A...

That’s why I drive with my npp mostly open. A couple of high rev down shift until the burble and popping (this seems to scare them) and I wind it out when taking off. I keep doing that until they...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 01-05-2020, 01:14 PM
Replies: 5
Views: 299
Posted By Level300
Did you try shifting faster or slower than you...

Did you try shifting faster or slower than you normally would?
Motor mounts?
The only other thing I can suggest is to test drive a used m6 camaro and see if it’s there too.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-05-2020, 12:18 PM
Replies: 3
Views: 220
Posted By Level300
Gotcha. Thanks!

Gotcha. Thanks!
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-05-2020, 11:14 AM
Replies: 3
Views: 220
Posted By Level300
Cam kit question...

Hi.

Iím doing preliminary research on whatís involved in putting in a cam and I have a few question.

You can only determine the pushrod length with the new cam installed. Then why do cam kits...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 01-05-2020, 08:54 AM
Replies: 5
Views: 299
Posted By Level300
Most if not all car manufacturers that use the...

Most if not all car manufacturers that use the tr6060 have this problem. I’ve read about this on ford and challenger forums so it’s not localized to camaros.

Mgw won’t cure the notchiness....
Forum: Camaro 1LE Forum 12-29-2019, 08:47 AM
Replies: 3
Views: 292
Posted By Level300
How many miles do you have on it?

How many miles do you have on it?
Forum: Garage / Tools Discussions 11-12-2019, 09:43 AM
Replies: 10
Views: 1,663
Posted By Level300
I think you really need to setup garage lighting...

I think you really need to setup garage lighting like lighting in a paint booth to have the best possible lighting. Overhead, angled overhead and along the sides. With led panels being really thin,...
Forum: 5th Gen Camaro SS LS LT General Discussions 11-07-2019, 06:00 AM
Replies: 8
Views: 825
Posted By Level300
I have this too. It’s sounds like it happens when...

I have this too. It’s sounds like it happens when the suspension loads and unloads. It is very annoying but luckily, my Headers and NPP sound much more pleasant that the squeak becomes almost faint....
Forum: 5th Gen Camaro SS LS LT General Discussions 11-02-2019, 04:34 PM
Replies: 12
Views: 1,006
Posted By Level300
I recently did this to my fiberglass hood. As...

I recently did this to my fiberglass hood. As commonly in life, your first attempt may end in sub par results. But that’s okay, nothing ventured, nothing gained. It looks simple to do but it’s the...
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 10-12-2019, 08:16 AM
Replies: 19
Views: 1,954
Posted By Level300
Kooks is a little over priced imo. For what you...

Kooks is a little over priced imo. For what you pay, you’d think they would have torque specs in the instructions and non leaking connections. But I have/had neither of those things. My decision to...
Forum: Tuning / Diagnostics -- engine and transmission 10-02-2019, 04:31 PM
Replies: 1
Views: 362
Posted By Level300
I've had the zt-2 for several years now. It was...

I've had the zt-2 for several years now. It was first used on my motorcycle many, many years ago. I've had no problems with it. I am currently using it in my camaro with a Palm Tungsten handheld....
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-25-2019, 07:19 AM
Replies: 32
Views: 1,628
Posted By Level300
https://www.camaro5.com/forums/showthread.php?t=31...

https://www.camaro5.com/forums/showthread.php?t=318683&highlight=Npp
It’s the first post.

Op read through all the posts. There are two ways of going about this mod. What I’m referring to is a...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-23-2019, 04:55 PM
Replies: 32
Views: 1,628
Posted By Level300
Yep! This is true. I just installed my headers...

Yep! This is true. I just installed my headers and it sounds great and not obnoxious.

There is a DYI post on the NPP that allows you to run in Stealth, Always Open or Factory. All you need is to...
Forum: Camaro 1LE Forum 09-11-2019, 12:35 PM
Replies: 13
Views: 1,893
Posted By Level300
I use royal purple and it seems to be a lot...

I use royal purple and it seems to be a lot better than factory fill. Before I swapped fluids, there would a lot of gear grinding from 1 to 2 and 2 to 3...now, only when it's cold does it grind but I...
Forum: Tuning / Diagnostics -- engine and transmission 09-10-2019, 05:30 PM
Replies: 621
Views: 120,244
Posted By Level300
I purchased a set of kooks long tubes and a sct...

I purchased a set of kooks long tubes and a sct x4 programmer from dynosteve. His prices are very competitive and he shipped quickly. He’s also very responsive. I sent him my original tune on a...
Forum: Camaro 1LE Forum 09-09-2019, 07:20 PM
Replies: 2
Views: 499
Posted By Level300
Thanks turbo.

Thanks turbo.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-09-2019, 06:21 PM
Replies: 6
Views: 564
Posted By Level300
Man, these headers are loud. You get on it just a...

Man, these headers are loud. You get on it just a little bit and it sounds mean. I feel like an Ahole at times. I love them for tailgaters, left lane dicks and people using their cell phones behind...
Forum: Camaro 1LE Forum 09-09-2019, 09:33 AM
Replies: 2
Views: 499
Posted By Level300
Cost effective slotted rotor suggestions...

My rotors need replacing soon so I am planning on getting slotted rotors for my daily driver. I do, on occasion do AutoX and Track Days, so something a little better than OEM but nothing crazy...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-09-2019, 08:57 AM
Replies: 6
Views: 564
Posted By Level300
Thanks man! I hated to do it but I had to cut it...

Thanks man! I hated to do it but I had to cut it off. I was late for work and I couldn't get the boot over the universal joint. It would be touching the header for a 1+ hour ride into work. With my...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-09-2019, 06:23 AM
Replies: 6
Views: 564
Posted By Level300
How close is too close for steering boot near header?

I just installed kooks LT headers yesterday. The install went fairly smooth but it was a tough one.

The rubber steering boot is about 1/8 to 1/4 near the tube. My headers are ceramic coated. How...
Forum: Camaro 1LE Forum 09-03-2019, 12:41 PM
Replies: 9
Views: 918
Posted By Level300
Nice! I bet you had a great time. The 1LE...

Nice! I bet you had a great time. The 1LE suspension is amazing. I never thought that a Camaro could ever corner this good. And the sound it makes....at full throttle...at the top end of the rev...
Forum: Camaro DIY & HOW-TO instructions & discussions 08-31-2019, 05:42 PM
Replies: 162
Views: 53,033
Posted By Level300
I just finished this mod. It’s pretty cool! I...

I just finished this mod. It’s pretty cool! I previously had the mild to wild controller but swapped it out because it doesn’t close all the time (I’m preparing for my long tubes and don’t want to...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-30-2019, 12:39 PM
Replies: 65
Views: 5,801
Posted By Level300
I don't have any experience with Hurst but MGW is...

I don't have any experience with Hurst but MGW is a work of art. Everything is precision made and it shifts solidly. It really brings out the drive-train slop and the clunking of the TR6060 lol. ...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-21-2019, 11:28 AM
Replies: 13
Views: 801
Posted By Level300
Are you getting your headers ceramic coated?

Are you getting your headers ceramic coated?
Forum: Cosmetics and Lighting Modification Discussions 07-28-2019, 07:26 PM
Replies: 5
Views: 578
Posted By Level300
Thanks.

Thanks.
Forum: Cosmetics and Lighting Modification Discussions 07-26-2019, 12:51 PM
Replies: 5
Views: 578
Posted By Level300
Downside to matte wrapped car...

I'm curious to find out the downside if any, of owning a daily driven matte wrapped car?

Thanks!
Forum: Road Course/Track and Autocross 07-23-2019, 03:49 PM
Replies: 6
Views: 1,447
Posted By Level300
What brand of drill bit did you guys buy to drill...

What brand of drill bit did you guys buy to drill through the pedals and how many did you use? It’s a nightmare trying to mark and drill these holes.

Update:
For those of you about to embark on...
Showing results 1 to 30 of 197

 
Forum Jump

All times are GMT -5. The time now is 09:14 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2020, vBulletin Solutions, Inc.