Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
BORLA
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 500
Search took 0.06 seconds.
Search: Posts Made By: h018871
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-21-2018, 08:30 AM
Replies: 17
Views: 334
Posted By h018871
612 at the flywheel 525 at the wheels. NA The...

612 at the flywheel 525 at the wheels. NA
The 42 lb injectors were at 90+ duty cycle so I went bigger to avoid a failure.
Lots of folks run boost a pumps, so they must be fine.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-19-2018, 12:35 PM
Replies: 17
Views: 334
Posted By h018871
I’ve got a 418 and ran out of injector. Went with...

I’ve got a 418 and ran out of injector. Went with 52lb. I don’t know about the SS pump, mine came with the ZL1 pump.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 06-17-2018, 12:42 AM
Replies: 3
Views: 224
Posted By h018871
If you have the original 2010 trans, it does not...

If you have the original 2010 trans, it does not have an output shaft support bearing in the tailshaft. It will probably be about the same $$ to repair yours or get another one with low miles. The...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-28-2018, 07:10 PM
Replies: 15
Views: 4,759
Posted By h018871
OP The motor comes out with the hood attached,...

OP
The motor comes out with the hood attached, but is easier if removed. I found it easier to remove the manual trans from below before pulling the engine. Pulling the radiator gives you more wiggle...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 05-09-2018, 03:42 PM
Replies: 6
Views: 421
Posted By h018871
olblue I have this in my notes from the last...

olblue
I have this in my notes from the last clutch install

ARP Flywheel Bolts (330-2802): Loctite 242 (Blue) on threads and ARP lube
under head. 85 lb/ft
Go in steps up to full torque value
...
Forum: Camaro 1LE Forum 05-09-2018, 09:10 AM
Replies: 12
Views: 782
Posted By h018871
Elite here on both my 1LE and MX5

Elite here on both my 1LE and MX5
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 05-08-2018, 01:03 PM
Replies: 32
Views: 1,667
Posted By h018871
I'm interested

I'm interested
Forum: Member Car Journals 05-06-2018, 01:28 PM
Replies: 155
Views: 43,308
Posted By h018871
MORE Maintenance........

WHEW! I guess things wear out at about 100K

When at Cresson, I noticed the car was not as smooth/predictable as I expected it to be. It has been ~ 6 months since my last track day and I accept...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-26-2018, 04:23 PM
Replies: 2
Views: 302
Posted By h018871
Thx to Cracka for this ...

Thx to Cracka for this
https://www.camaro5.com/forums/showthread.php?t=394512

I PM'd Cracka and he sent me a link to his photobucket that had the pics. I'm sure he would do the same for you.
Forum: 5th Gen Camaro SS LS LT General Discussions 04-23-2018, 01:02 PM
Replies: 4
Views: 352
Posted By h018871
You’ll sit higher in the Ricaros, because the...

You’ll sit higher in the Ricaros, because the foam is more dense.
Lean over, slouch or trade your car for one that doesn’t have a sunroof. The first two options are the easiest
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 04-20-2018, 09:53 PM
Replies: 25
Views: 3,021
Posted By h018871
Put gasket goop along the bottom of the rear...

Put gasket goop along the bottom of the rear cover and in the bottom corners where the pan meets the block. Just put it on and tighten the bolts
Straight forward
Forum: Member Car Journals 04-20-2018, 09:31 PM
Replies: 2,086
Views: 233,456
Posted By h018871
Good wear on the tires, alignment is spot on for...

Good wear on the tires, alignment is spot on for what you’re doing

The ac belt looks narrow, I counted 3 ribs.......but it doesn’t look like it’s shed a rid or two. Verify the new one. I could be...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-14-2018, 04:54 PM
Replies: 6
Views: 377
Posted By h018871
Suggestion Call spec, measure everything from...

Suggestion
Call spec, measure everything from the crank flange to the pressure plate fingers and add it up to get the stack height for the parts you have. Verify it is the same as spec says it...
Forum: Camaro 1LE Forum 04-11-2018, 05:48 PM
Replies: 84
Views: 12,923
Posted By h018871
you can unbolt the lower attachment of the...

you can unbolt the lower attachment of the seatbelt and pass it through the hole in the seat back.............
Forum: Camaro 1LE Forum 04-11-2018, 05:40 PM
Replies: 60
Views: 1,927
Posted By h018871
OP, you win! 96,000 on mine

OP, you win!
96,000 on mine
Forum: Road Course/Track and Autocross 03-29-2018, 10:56 AM
Replies: 107
Views: 22,239
Posted By h018871
MSR Cresson

MSR Cresson TX, 3.1 CW, 2013 1LE, Manual, 2:37.76, Goodyear F1G2, Dry
Forum: 5th Gen Camaro SS LS LT General Discussions 03-29-2018, 10:30 AM
Replies: 5
Views: 636
Posted By h018871
the pulley is loose on the crank and wore the...

the pulley is loose on the crank and wore the snout down = new crankshaft
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 03-29-2018, 10:23 AM
Replies: 20
Views: 1,460
Posted By h018871
Z28 LH Axle - 23473010 Z28 RH Axle - 23473011 ...

Z28 LH Axle - 23473010
Z28 RH Axle - 23473011
1LE/Z28 Axle Nut - 11611234 (x2)
Forum: Suspension / Brakes / Chassis 03-28-2018, 08:17 AM
Replies: 9
Views: 926
Posted By h018871
ZL1/Z28 Hubs - 25954415 (ACDelco RW20-119) ...

ZL1/Z28 Hubs - 25954415 (ACDelco RW20-119)
http://www.camaro5.com/forums/showthread.php?t=434445&page=2
look at post # 28

I found new ones on ebay from rolling automotive for $50ea! heck of a...
Forum: Suspension / Brakes / Chassis 03-28-2018, 08:03 AM
Replies: 7
Views: 382
Posted By h018871
Try these: http://www.provenwicked.com/ ...

Try these: http://www.provenwicked.com/

Contact them and share your current issues. they are very responsive.
Forum: Camaro 1LE Forum 03-28-2018, 07:26 AM
Replies: 10
Views: 971
Posted By h018871
Welcome back Lio! The car is looking good.

Welcome back Lio! The car is looking good.
Forum: Member Car Journals 03-27-2018, 11:57 AM
Replies: 155
Views: 43,308
Posted By h018871
Beautiful weekend! My son brought out his ATS-V,...

Beautiful weekend! My son brought out his ATS-V, that is a fun car!
Forum: Road Course/Track and Autocross 03-27-2018, 11:51 AM
Replies: 70
Views: 5,977
Posted By h018871
Thanks for this tip, it worked out great! I...

Thanks for this tip, it worked out great!

I ran Cresson 3.1 over the weekend & swapped over to the "track deflectors". No issues and they do scoop up a lot of air. I had bugs splattered across...
Forum: Member Car Journals 03-26-2018, 10:33 PM
Replies: 155
Views: 43,308
Posted By h018871
While here, the deflectors

I ran the "track" deflectors, they had bugs on the lower section (indicating they are scooping up air). I pushed the pads to a bit thinner than I normally do, the rotors did not crack. Funny thing...
Forum: Member Car Journals 03-26-2018, 10:27 PM
Replies: 155
Views: 43,308
Posted By h018871
Back to the 6th Gen Control Arms

Took the car to Cresson, 3.1 mile course this weekend. Thiw was the first time since swapping control arms I got to run the car on the 285 square setup. I've been dailying the car for 5 months, so I...
Forum: Camaro 1LE Forum 03-26-2018, 08:26 PM
Replies: 7
Views: 735
Posted By h018871
Sorry, i'm sooooooo late in getting back to this....

Sorry, i'm sooooooo late in getting back to this.

Today I performed an experiment, I sucked out the GTO reservoir and wiped it clean. Then I fillid it up with ATE blue, then sucked through the...
Forum: Member Car Journals 03-17-2018, 06:27 PM
Replies: 2,086
Views: 233,456
Posted By h018871
You’ve convinced me! I’ll have to give it a go

You’ve convinced me! I’ll have to give it a go
Forum: Member Car Journals 03-17-2018, 10:47 AM
Replies: 2,086
Views: 233,456
Posted By h018871
My bad 🤗 I meant, track guys / chin /...

My bad 🤗
I meant, track guys / chin / PCA........
Forum: Member Car Journals 03-16-2018, 05:09 PM
Replies: 2,086
Views: 233,456
Posted By h018871
Nice photos. Car's looking great! What group...

Nice photos. Car's looking great!

What group do you run with at Eagles Canyon?

Will you be at Cresson next weekend?
Forum: Camaro DIY & HOW-TO instructions & discussions 03-10-2018, 03:54 PM
Replies: 35
Views: 16,176
Posted By h018871
camguynj the factory engine ground goes between...

camguynj
the factory engine ground goes between the front of the passenger head to the bottom of the ABS bracket (on a 13 at least)
it is a large gauge wire, looks like a hose.........it is the one...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 06:31 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2018, vBulletin Solutions, Inc.