Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Vararam
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.08 seconds. Search: Posts Made By: CamaroCracka
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls Yesterday, 07:16 AM
Replies: 3
Views: 191
Posted By CamaroCracka
a compressor can be failing and still deliver...

a compressor can be failing and still deliver cold air. You would have to connect some gauges and see what the high and low pressures are.

I had to replace the compressor on my turbo car because...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing Yesterday, 06:54 AM
Replies: 6
Views: 254
Posted By CamaroCracka
I've done it multiple times. Get some fender...

I've done it multiple times. Get some fender covers so you can lay the condenser on the passenger side without fear of scratching the paint. You can even leave the trans hooked up but you will need...
Forum: 5th Gen Camaro SS LS LT General Discussions Yesterday, 06:40 AM
Replies: 7
Views: 329
Posted By CamaroCracka
You have to do the cost benefit analysis for...

You have to do the cost benefit analysis for yourself. Anyone running boost can see big benefits by running e85. For those not running boost, my rule of thumb would be if the use of race fuel would...
Forum: Forced Induction - V8 04-22-2024, 11:31 AM
Replies: 3
Views: 195
Posted By CamaroCracka
I ran meth until I went e85. The nylon lines and...

I ran meth until I went e85. The nylon lines and fittings tend to leak over time and reassembly when your working on the car. Never had a problem with the Snow pump, but their controller died and...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-21-2024, 03:01 PM
Replies: 2
Views: 227
Posted By CamaroCracka
I had an Ideal Garage master cylinder and ended...

I had an Ideal Garage master cylinder and ended up going back to OEM because it was leaking internally. All the clutch issues I've had on both cars in relation to pedal not coming back were fixed...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-18-2024, 07:57 AM
Replies: 6
Views: 345
Posted By CamaroCracka
You would have to turn it hard enough for the...

You would have to turn it hard enough for the carrier's internal clutches to slip.
Forum: Forced Induction - V8 04-17-2024, 06:53 AM
Replies: 14
Views: 547
Posted By CamaroCracka
I don't run a shield on my heater lines and the...

I don't run a shield on my heater lines and the passenger side header even burnt the foam off the aluminum line. I do tuck a lot behind the heat shield that runs up from the trans tunnel and covers...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 04-17-2024, 06:48 AM
Replies: 9
Views: 502
Posted By CamaroCracka
All manufacturers eventually discontinue all...

All manufacturers eventually discontinue all parts. If you want to race old iron, you either need to invest in a stock of used parts or buy replacements from the aftermarket. DSSVs were over a grand...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-16-2024, 02:24 PM
Replies: 12
Views: 593
Posted By CamaroCracka
Summit has a 415 short block for $4200, $6200 for...

Summit has a 415 short block for $4200, $6200 for GM LS3 long block. When my vert spun a rod I had a 416 built for 7k and installed for another thousand. That included a new clutch and a cam swap.
...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-16-2024, 02:09 PM
Replies: 11
Views: 485
Posted By CamaroCracka
Looks like the Spohn brace with the two...

Looks like the Spohn brace with the two additional sides to make a triangle. It might be good if you wanted to cut out the cross member to remove the oil pan and not replace it. One guy did that with...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-16-2024, 02:06 PM
Replies: 8
Views: 458
Posted By CamaroCracka
I like the ones with the chrome naked lady on...

I like the ones with the chrome naked lady on them.
Forum: 5th Gen Camaro SS LS LT General Discussions 04-16-2024, 02:03 PM
Replies: 3
Views: 283
Posted By CamaroCracka
You may have four front wheels on the car....

You may have four front wheels on the car. Measure the inside of the tire barrels to see if they are the same width. Stock wheels are 20x8 and 20x9. You can also look on the back of the wheel and see...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-15-2024, 08:50 AM
Replies: 25
Views: 805
Posted By CamaroCracka
Pretty sure the Mantic instructions said a light...

Pretty sure the Mantic instructions said a light coat of grease on the input shaft. I could be wrong, but I did the same thing, sliding the clutch discs on to the input shaft to make sure they were...
Forum: Forced Induction - V8 04-15-2024, 08:41 AM
Replies: 14
Views: 547
Posted By CamaroCracka
I don't have AGP, but my single set up loves to...

I don't have AGP, but my single set up loves to melt loom in that area. This stuff holds up to the heat better than any other loom I have found, except maybe the silicone covered stuff, which is not...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-10-2024, 07:33 PM
Replies: 6
Views: 187
Posted By CamaroCracka
My fan plug burned with just the stock fans...

My fan plug burned with just the stock fans running on it. I would definitely just tap into the fan feed as trigger for an additional relay with a separate power source.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-09-2024, 02:29 PM
Replies: 39
Views: 1,635
Posted By CamaroCracka
Definitely, maybe it was because mine was built...

Definitely, maybe it was because mine was built during Covid, but I twisted it in half at a lot less power. Looked to me like the weld penetration was bad and it was taken care of, but it makes me...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 04-07-2024, 12:30 PM
Replies: 9
Views: 485
Posted By CamaroCracka
That half liter difference between the SS and Zl1...

That half liter difference between the SS and Zl1 TR6060s is the cooler lines and cooler. When I put diff coolers on my cars they took approximately 4.5 quarts to refill with the cooler in place.
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 04-07-2024, 12:21 PM
Replies: 19
Views: 1,125
Posted By CamaroCracka
The stock 355 l99 pump can cavitate at high rpm...

The stock 355 l99 pump can cavitate at high rpm aerating the oil. They used to run a similar pump in the LS4 5.3 that I ran for a while in another engine. Low cost pump that builds tons of pressure,...
Forum: Suspension / Brakes / Chassis 04-07-2024, 12:13 PM
Replies: 6
Views: 402
Posted By CamaroCracka
Here is what I have.

Here is what I have.
Forum: 5th Gen Camaro SS LS LT General Discussions 04-05-2024, 10:47 AM
Replies: 1
Views: 192
Posted By CamaroCracka
Long duration cams respond well to steeper gears....

Long duration cams respond well to steeper gears. Superchargers tend to need less gear but centrifugals come in later so you should be ok if you don't get too crazy on the power level.
Forum: 5th Gen Camaro SS LS LT General Discussions 04-02-2024, 05:25 AM
Replies: 9
Views: 307
Posted By CamaroCracka
The front is the harder part to get in the air,...

The front is the harder part to get in the air, if you get a long reach, low profile jack, you won't need any blocks to get a jack under it. Hell, even at stock height you really need a long reach,...
Forum: Chevy Camaro vs... 04-01-2024, 02:14 PM
Replies: 10
Views: 8,556
Posted By CamaroCracka
That would have actually been a very cool option...

That would have actually been a very cool option as there are so many turbo 5.3s you would have had turbo Gen6s everywhere. Reminds me of the low option muscle cars we drove in the 80s. We could not...
Forum: Forced Induction - V8 03-29-2024, 07:43 AM
Replies: 2
Views: 222
Posted By CamaroCracka
I'm at about that at WOT on E85 using a AEM gauge.

I'm at about that at WOT on E85 using a AEM gauge.
Forum: 5th Gen Camaro SS LS LT General Discussions 03-27-2024, 07:09 PM
Replies: 9
Views: 394
Posted By CamaroCracka
Even my 02 Silverado has an oil level sensor on...

Even my 02 Silverado has an oil level sensor on the side of the pan. Pretty common on LS.
Forum: 5th Gen Camaro SS LS LT General Discussions 03-27-2024, 07:04 AM
Replies: 43
Views: 1,840
Posted By CamaroCracka
It's already happening for the 6th Gens. You are...

It's already happening for the 6th Gens. You are starting to see threads where their parts are no longer available.

I don't think Mary Barra sees muscle car enthusiasts as a GM market anymore,...
Forum: 5th Gen Camaro SS LS LT General Discussions 03-26-2024, 07:04 AM
Replies: 43
Views: 1,840
Posted By CamaroCracka
This is exactly how YearOne got started....

This is exactly how YearOne got started. Manufacturers were selling of truckloads of their NOS parts, someone recognized the value and started a company based on it. Then they started making parts...
Forum: 5th Gen Camaro SS LS LT General Discussions 03-25-2024, 05:19 AM
Replies: 33
Views: 1,251
Posted By CamaroCracka
Never ran them, but externally they look exactly...

Never ran them, but externally they look exactly like the 1LE axle. I have seen some info saying they run different CV joints than the 1LE, but I don't know that to be fact. They are supposed to be...
Forum: Tuning / Diagnostics -- engine and transmission 03-21-2024, 05:59 AM
Replies: 8
Views: 320
Posted By CamaroCracka
Guys on the HPTuners forum share tunes all the...

Guys on the HPTuners forum share tunes all the time, but if you are not a skilled tuner, I would not be using HPTuners on your own. You can buy an HPTuners device on many sites including Amazon or...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-21-2024, 05:25 AM
Replies: 39
Views: 1,635
Posted By CamaroCracka
True, but no more costly than CF and would never...

True, but no more costly than CF and would never break at my level. The added weight would be my biggest reason for sticking with a stock shaft.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-20-2024, 06:45 PM
Replies: 39
Views: 1,635
Posted By CamaroCracka
I feel like the stock shafts are stronger than...

I feel like the stock shafts are stronger than aluminum. If I ever do another one piece shaft it will be CF or chromoly.
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 08:02 PM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.