Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Phastek Performance
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 16 of 16
Search took 0.01 seconds.
Search: Posts Made By: Eastbaycamaro
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-02-2022, 05:51 AM
Replies: 18
Views: 470
Posted By Eastbaycamaro
If I recall correctly the drain and fill plugs...

If I recall correctly the drain and fill plugs have a o-ring seal. In you case maybe the drain plug o-ring needs to be replaced
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-26-2022, 07:19 AM
Replies: 56
Views: 3,420
Posted By Eastbaycamaro
I am looking at either gulf coast or pstds 3.5...

I am looking at either gulf coast or pstds 3.5 aluminum. Currently have a 3x.083 mild steel with 1350 for the strange s60 rear and a sonnax 1350 to tr6060 Not to happy with it seems to vibrate at...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-05-2022, 06:07 AM
Replies: 47
Views: 3,673
Posted By Eastbaycamaro
It’s not to bad of a job. Might want to mark the...

It’s not to bad of a job. Might want to mark the position of the drive shaft to the trans and rear diff flange before you remove it. The trans gets very close to the tunnel on the passenger side...
Forum: Dragstrip and Launch Techniques Discussion 04-03-2022, 03:09 PM
Replies: 10
Views: 1,061
Posted By Eastbaycamaro
That’s awesome

That’s awesome
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-03-2022, 03:06 PM
Replies: 47
Views: 3,673
Posted By Eastbaycamaro
The other thing I notice with my rxt is that...

The other thing I notice with my rxt is that there is some rattling noise about 1600 rpm. I read that the rxt maybe a bit noisy. I will find out if it’s the clutch that’s noisy after I change it out....
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-03-2022, 08:24 AM
Replies: 47
Views: 3,673
Posted By Eastbaycamaro
I notice after I got the rxt that it’s a solid...

I notice after I got the rxt that it’s a solid hub on both clutch disk. After that I broke my axle/spider gears then upgraded to Eaton trutrac and motive 4:10 and after about 7 passes I broke a bunch...
Forum: Transmission / Driveline 04-03-2022, 08:12 AM
Replies: 1
Views: 574
Posted By Eastbaycamaro
I got one for sale $450

I got one for sale $450
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-25-2022, 03:31 PM
Replies: 47
Views: 3,673
Posted By Eastbaycamaro
Ram single disk set up with the spring hub

Ram single disk set up with the spring hub
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-25-2022, 07:22 AM
Replies: 47
Views: 3,673
Posted By Eastbaycamaro
I will be removing my McLeod RXT twin disks next...

I will be removing my McLeod RXT twin disks next week and put it up for sale. Got about 15 passes at the drag strip. It is a solid hub design pn# 6932-07
Forum: Local Marketplace 03-20-2022, 08:09 AM
Replies: 0
Views: 339
Posted By Eastbaycamaro
Trutrac $475

Trutrac for sale $450
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 03-20-2022, 07:49 AM
Replies: 10
Views: 1,283
Posted By Eastbaycamaro
I tore into it. It was a project. Had to drop the...

I tore into it. It was a project. Had to drop the front sub frame about 3-4 inches and raise the motor as high as it could go. Removed the radiator, water pump, and oil cooler. Loosen and slide the...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 03-19-2022, 09:12 AM
Replies: 10
Views: 1,283
Posted By Eastbaycamaro
I had about 60k and did it myself. I tried the...

I had about 60k and did it myself. I tried the oil pressure sensor but no help. Then I heard the lifters clacking so I know the oil pressure was low. Did all the work myself
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 03-19-2022, 09:06 AM
Replies: 10
Views: 1,283
Posted By Eastbaycamaro
I had to change my oil pump

I had to change my oil pump
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-19-2022, 09:01 AM
Replies: 9
Views: 880
Posted By Eastbaycamaro
What axles are you going to use with the tru trac

What axles are you going to use with the tru trac
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-10-2022, 07:08 AM
Replies: 9
Views: 880
Posted By Eastbaycamaro
Removed my diff last week. I pulled the axles....

Removed my diff last week. I pulled the axles. Disconnect the toe link,upper control arm and lower control arm at spindle. Remove the abs sensor and you should be able to move the spindle out far...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 01-28-2022, 06:26 AM
Replies: 11
Views: 952
Posted By Eastbaycamaro
Ck out...

Ck out https://www.gulfcoastdriveshaft.com/camaro-gen-5/
They seem to have a one piece drive shaft that bolts on with no adapters.
Showing results 1 to 16 of 16

 
Forum Jump

All times are GMT -5. The time now is 11:45 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2022, vBulletin Solutions, Inc.