Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Roto-Fab
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 500
Search took 0.07 seconds.
Search: Posts Made By: Badbubba
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 12-02-2022, 10:36 AM
Replies: 12
Views: 313
Posted By Badbubba
I have the Metco, but with the stock driveshaft. ...

I have the Metco, but with the stock driveshaft. Nice item and easy install.
Forum: 5th Gen Camaro SS LS LT General Discussions 11-29-2022, 10:26 AM
Replies: 15
Views: 527
Posted By Badbubba
I had zero issues after spraying belt dressing on...

I had zero issues after spraying belt dressing on the a/c belt. A few short sprays on the belt eliminated the noise temporarily. Thus informing me it was a belt issue. I replaced the belt after I...
Forum: 5th Gen Camaro SS LS LT General Discussions 11-28-2022, 08:41 AM
Replies: 15
Views: 527
Posted By Badbubba
Remove the serpentine and run it somewhere safe. ...

Remove the serpentine and run it somewhere safe. If the noise is still there, spray belt dressing on a/c belt and pulley surfaces to see if the sound changes. I had a noise, chirping sound. Was...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 11-17-2022, 04:54 PM
Replies: 13
Views: 571
Posted By Badbubba
1st post for you. 👍 How many miles? Are you...

1st post for you. 👍 How many miles? Are you having issues? Hard starting? I use CRC GDI cleaner on a 3.6 LFX Equinox. The LFX replaced the LLT in the 2012 Camaro, very similiar engines. The...
Forum: Dragstrip and Launch Techniques Discussion 11-17-2022, 09:12 AM
Replies: 5
Views: 505
Posted By Badbubba
CTAP and LNC 2000 for launch control. Push the...

CTAP and LNC 2000 for launch control. Push the clutch pedal down, press and release a momentary button which latches the circuit, gas pedal to floor, release clutch, latch circuit drops. The value...
Forum: 5th Gen Camaro SS LS LT General Discussions 10-20-2022, 12:35 PM
Replies: 22
Views: 2,240
Posted By Badbubba
Any mods done? Check oil level, head gasket leak...

Any mods done? Check oil level, head gasket leak detector (it's a 2010 LS3 so there is a rad cap). Could have got combustion gases in the cooling system, which would cause overheating. The LS3...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-04-2022, 06:07 PM
Replies: 17
Views: 768
Posted By Badbubba
18077 and 18078 gates. This DIY thread covers...

18077 and 18078 gates.
This DIY thread covers pretty much everything.

https://www.camaro5.com/forums/showthread.php?t=107304
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-03-2022, 10:34 PM
Replies: 17
Views: 768
Posted By Badbubba
I relocated mine with Gates hoses. You'll want...

I relocated mine with Gates hoses. You'll want to carefully cut the hoses, especially at the heater core. It appears GM used a sealant on the connections. Twisting too much could damage the heater...
Forum: Forced Induction - V8 10-03-2022, 08:04 AM
Replies: 18
Views: 9,270
Posted By Badbubba
Just by reading the original post, it could be...

Just by reading the original post, it could be hard to know if it was a super charger or turbo. Their signature states Maggie. So the operation is different. For a turbo, it has a recirculating...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-27-2022, 03:29 PM
Replies: 4
Views: 678
Posted By Badbubba
Use lambda if you can. Should just be able to...

Use lambda if you can. Should just be able to push a button on the wide band for the meter display. With afr, you need to know the stochiometric value of the fuel and and what stoichiometric value...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-28-2022, 06:46 PM
Replies: 69
Views: 8,511
Posted By Badbubba
As NOT A 45 stated, the receiver is attached to...

As NOT A 45 stated, the receiver is attached to the condenser. It contains a desiccant, which is the filter/ drier for the system. Anytime a system is opened up, it is recommended to change the...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-28-2022, 03:43 PM
Replies: 69
Views: 8,511
Posted By Badbubba
Sounds more like a clutch/coil issue. If you...

Sounds more like a clutch/coil issue. If you have power to the compressor, which would be the coil, then you should hear it pickup and see it turn. Since it is attempting to activate the ac system,...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-28-2022, 03:23 PM
Replies: 69
Views: 8,511
Posted By Badbubba
Then what code does it set for a low charge? And...

Then what code does it set for a low charge? And how is it cleared? Is a message displayed in the DIC?
Forum: 5th Gen Camaro SS LS LT General Discussions 07-28-2022, 12:03 PM
Replies: 69
Views: 8,511
Posted By Badbubba
If you remove the mounting bolts for the...

If you remove the mounting bolts for the condenser lines, it can be flipped up over to the driver's side, on top of the intake. No need to recover and charge. I don't know how they would have had...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-28-2022, 11:44 AM
Replies: 69
Views: 8,511
Posted By Badbubba
OP. One other thing. Check the ac compressor...

OP. One other thing. Check the ac compressor clutch. The front hub is 2 pieces and is connected with a polymer rubber. Similiar to how the harmonic damper is constructed. The coil energizes and...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-28-2022, 11:26 AM
Replies: 69
Views: 8,511
Posted By Badbubba
I understand that with a rise in temperature,...

I understand that with a rise in temperature, there will be a rise in pressure. Even if the ac system was heated to 170°F, the OP still had over 100psi. That exceeds the low pressure "switch"...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-27-2022, 06:37 PM
Replies: 69
Views: 8,511
Posted By Badbubba
If I'm reading your thread correctly, you have...

If I'm reading your thread correctly, you have 101 or 123 psi on the low side, suction side, without the compressor running. If so, then no damage to lines or condenser to cause a leak. Usually...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 07-26-2022, 02:09 PM
Replies: 5
Views: 792
Posted By Badbubba
Are the cast exhaust manifolds still on the car? ...

Are the cast exhaust manifolds still on the car? Headers will allow more noise to be transmitted.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-07-2022, 04:52 PM
Replies: 70
Views: 9,821
Posted By Badbubba
Piece of mind knowing these components will last...

Piece of mind knowing these components will last 20k miles. I won't even bother with inspecting for further use. Just replace.
Forum: 5th Gen Camaro SS LS LT General Discussions 06-30-2022, 12:12 AM
Replies: 8
Views: 1,478
Posted By Badbubba
Drain and fill will almost take 4 quarts. Had a...

Drain and fill will almost take 4 quarts. Had a little extra left in my gallon of Amsoil.
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 06-08-2022, 10:19 AM
Replies: 2
Views: 694
Posted By Badbubba
2010-11 V6 and V8 cradles are the same. Pictured...

2010-11 V6 and V8 cradles are the same. Pictured is a V8, but the attachment should be the same. It is your power steering hose. The other 2 hoses are for the transmission cooler. I would think...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-06-2022, 05:00 PM
Replies: 55
Views: 5,002
Posted By Badbubba
1st start after finishing install on Memorial...

1st start after finishing install on Memorial Day. Primed the oil pump by removing the front plug. Had 40 psi after guage sweep. Still on the bolt-ons tune.

https://youtu.be/ptd4lusvWog

2nd...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-06-2022, 03:20 PM
Replies: 24
Views: 3,763
Posted By Badbubba
Received tires from both. No issues.

Received tires from both. No issues.
Forum: 5th Gen Camaro SS LS LT General Discussions 06-06-2022, 10:30 AM
Replies: 14
Views: 2,192
Posted By Badbubba
Get a quality set. I have Robinaire. Vibration...

Get a quality set. I have Robinaire. Vibration free. That way you can always check the high side. You can buy an adapter to go from the normal screw on service port hose to the R134A push on port.
Forum: 5th Gen Camaro SS LS LT General Discussions 06-06-2022, 10:20 AM
Replies: 14
Views: 2,192
Posted By Badbubba
[QUOTE=silversleeper;11182822]AC is hard for an...

[QUOTE=silversleeper;11182822]AC is hard for an amateur like myself to get correct.
https://www.camaro5.com/forums/showthread.php?t=559278
has more info.
I'll attach a chart for the camaro from...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-04-2022, 11:18 PM
Replies: 7
Views: 965
Posted By Badbubba
Yep. Go with everything you want at once. I've...

Yep. Go with everything you want at once. I've done mine in stages. Costs more. The LS3/L99 platform has been out there long enough. There are proven products.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-04-2022, 11:09 PM
Replies: 7
Views: 965
Posted By Badbubba
Pick a cam for FI not N/A. Went with the SS3...

Pick a cam for FI not N/A. Went with the SS3 cam, manual, bucks fairly hard. But still tuned for bolt ons. Message GPI,, sure they'll point you in the right direction. Suspension means a lot if...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-04-2022, 11:07 PM
Replies: 10
Views: 2,077
Posted By Badbubba
That sucks. Because of all the blend door...

That sucks. Because of all the blend door issues, I keep the temp control 2-3 notches off max cool.
Forum: 5th Gen Camaro SS LS LT General Discussions 06-04-2022, 10:41 PM
Replies: 14
Views: 1,837
Posted By Badbubba
Just added the C5R timing chain and LS2 guide...

Just added the C5R timing chain and LS2 guide with my cam swap. But no issues with the stock stuff.
Forum: 5th Gen Camaro SS LS LT General Discussions 06-03-2022, 09:36 PM
Replies: 14
Views: 1,837
Posted By Badbubba
Wait, what????? My 2010? Um, ok Google. The LLT...

Wait, what????? My 2010? Um, ok Google. The LLT V6 had some timing chain issues.
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 08:50 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2022, vBulletin Solutions, Inc.