Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Vararam
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 500
Search took 0.08 seconds.
Search: Posts Made By: dreksnot
Forum: Forced Induction - V8 Yesterday, 12:52 PM
Replies: 2
Views: 136
Posted By dreksnot
The line from the rear of the intake manifold to...

The line from the rear of the intake manifold to the brake booster is a good line to "T" for a vacuum/boost source. Some run a vacuum block...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-28-2022, 01:01 PM
Replies: 12
Views: 314
Posted By dreksnot
I have that same Metco WITH the extension for my...

I have that same Metco WITH the extension for my TR6060 and DSS driveshaft. Pretty easy to install and no fitment issues.
Forum: Forced Induction - V8 11-23-2022, 08:38 PM
Replies: 10
Views: 373
Posted By dreksnot
That looks secure.

That looks secure.
Forum: Forced Induction - V8 11-23-2022, 08:36 PM
Replies: 35
Views: 1,047
Posted By dreksnot
Whipple, for sure! Only SC I’d go if I didn’t...

Whipple, for sure! Only SC I’d go if I didn’t have twins.
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 11-11-2022, 05:36 PM
Replies: 12
Views: 363
Posted By dreksnot
This is typical of running E85; perhaps even if...

This is typical of running E85; perhaps even if running E10 with regular pump gas. My catch can lines junk up with this tan baby poo stuff. Tough to clean and I've found brake cleaner to work best....
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 11-11-2022, 10:58 AM
Replies: 12
Views: 363
Posted By dreksnot
You running E85?

You running E85?
Forum: Forced Induction - V8 11-10-2022, 12:39 PM
Replies: 31
Views: 1,097
Posted By dreksnot
I ran a LPE twin-fuel (CTS-V pump) with a Kenne...

I ran a LPE twin-fuel (CTS-V pump) with a Kenne Bell boost-a-pump (BAP) for 745whp on E66 on LS3, FWIW. You can yield, maybe, 50whp less with a ZL1 pump and BAP.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-02-2022, 01:57 AM
Replies: 113
Views: 8,346
Posted By dreksnot
The "we'll see" turned into "we saw." The calc...

The "we'll see" turned into "we saw." The calc of 9,750rpm was for 200mph. I ran out of gear and did 203.5mph so more like 9,920rpm on the DSS CF shaft.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-18-2022, 01:54 PM
Replies: 42
Views: 3,964
Posted By dreksnot
When I spoke with one of the old timer M&H techs,...

When I spoke with one of the old timer M&H techs, he sternly said to run bias fronts with bias rears, and can run bias fronts with radial rears BUT do not run radial fronts with bias rears. He was...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-17-2022, 03:45 PM
Replies: 42
Views: 3,964
Posted By dreksnot
I was having the opposite with the "older" BSB...

I was having the opposite with the "older" BSB controller - having to be near zero for the Delay (hoping that added resistor does the trick), and sometimes the pedal would stay down (engage) too long...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-12-2022, 05:35 PM
Replies: 42
Views: 3,964
Posted By dreksnot
When I was at my track rental last month, Billy ...

When I was at my track rental last month, Billy swapped controllers out with me - the newer one has a resistor installed to cut/reduce EMI from a 2-step. As for the OEM clutch position sensor - it...
Forum: Tuning / Diagnostics -- engine and transmission 10-11-2022, 12:46 PM
Replies: 47
Views: 2,583
Posted By dreksnot
It's :peace:stock:peace:

It's :peace:stock:peace:
Forum: Tuning / Diagnostics -- engine and transmission 10-10-2022, 10:23 PM
Replies: 47
Views: 2,583
Posted By dreksnot
I presume you saved those in v5.0.4. I haven't...

I presume you saved those in v5.0.4. I haven't upgraded to that yet... not sure if I want to.
Forum: Tuning / Diagnostics -- engine and transmission 10-10-2022, 05:13 PM
Replies: 47
Views: 2,583
Posted By dreksnot
What do all your O2 sensors look like on the log?...

What do all your O2 sensors look like on the log? Sine wave? What?
Forum: Tuning / Diagnostics -- engine and transmission 10-09-2022, 10:33 PM
Replies: 47
Views: 2,583
Posted By dreksnot
Sounding more like a bad O2 sensor if the tune...

Sounding more like a bad O2 sensor if the tune is, indeed, stock.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-09-2022, 03:01 PM
Replies: 113
Views: 8,346
Posted By dreksnot
Did you get the Delrin bushings? I just got a...

Did you get the Delrin bushings? I just got a set of poly offsets but didn't look real well to see if they would fit with my 9" beforehand - they won't.
Forum: Tuning / Diagnostics -- engine and transmission 10-09-2022, 11:58 AM
Replies: 47
Views: 2,583
Posted By dreksnot
Sounds about right. When approximately 20sec...

Sounds about right. When approximately 20sec after startup and shifting over from OL to CL, your O2 sensors have heated up and start to command AFR. Log "Fuel System #1 Statue (SAE) and you can see...
Forum: Tuning / Diagnostics -- engine and transmission 10-07-2022, 06:16 PM
Replies: 47
Views: 2,583
Posted By dreksnot
What has been done to the car (mods)? Idle ...

What has been done to the car (mods)?

Idle Startup Airflow only tapers for 4 seconds. Engine coolant and inlet air temperature affect idle; changes spark, airflow, fueling and tables that...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-07-2022, 04:23 PM
Replies: 14
Views: 879
Posted By dreksnot
Don't have to hard launch the car for the Mile...

Don't have to hard launch the car for the Mile runs. Just get started and roll in to the throttle. Good thing I went with the billet 5th gear in the RPM TR6060 - I'll have to spin the motor...
Forum: Tuning / Diagnostics -- engine and transmission 10-07-2022, 04:09 PM
Replies: 47
Views: 2,583
Posted By dreksnot
I hope "someone" had mind enough to save the...

I hope "someone" had mind enough to save the starting tune (one on the car before implementing changes) before flashing. Just reflash the original and go from there. If "someone" didn't.....
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-07-2022, 01:44 PM
Replies: 14
Views: 879
Posted By dreksnot
As you know, I've tried all kinds of gearing with...

As you know, I've tried all kinds of gearing with my full weight 4,450lbs turbo M6 car [3.23, 3.25 (last), 3.73, 4.11 (current)]. I've tried various RPMs (3,500-5000rpm) to launch, and various boost...
Forum: Forced Induction - V8 09-17-2022, 11:59 AM
Replies: 7
Views: 825
Posted By dreksnot
Local racetrack sells race fuels and E85 for a...

Local racetrack sells race fuels and E85 for a good price
Forum: Forced Induction - V8 09-16-2022, 11:33 AM
Replies: 7
Views: 825
Posted By dreksnot
"They" say "don't run anything flammable through...

"They" say "don't run anything flammable through the cockpit." On that note, I ran my meth line from the battery well tank, driver's side of the trunk behind the rear seat, under the driver's door...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 08-27-2022, 11:06 AM
Replies: 13
Views: 1,025
Posted By dreksnot
I've been running my Triple Monster w/o any...

I've been running my Triple Monster w/o any return spring or OEM for years. Least resistance feel. I've tried adding an assistance spring but didn't like the added resistance.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 08-19-2022, 04:32 PM
Replies: 10
Views: 834
Posted By dreksnot
Thinking so. You can do a part number search by...

Thinking so. You can do a part number search by year and model to verify that. Also, the RevShift is pretty inexpensive and very easy to install and remove. You could always get one, see how it...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 08-19-2022, 11:22 AM
Replies: 10
Views: 834
Posted By dreksnot
I ran the RevShift poly mount for years. Then I...

I ran the RevShift poly mount for years. Then I installed the OEM in again (mine is 2013 so those are a little stiffer than previous years). I only noticed more NVH with it installed. I am not...
Forum: Forced Induction - V8 08-18-2022, 09:31 AM
Replies: 2
Views: 599
Posted By dreksnot
I think they say they’re not E85 compatible. I...

I think they say they’re not E85 compatible. I ran my LPE twin fuel for over 7 years on E, and with a BAP. It’s a CTS-V pump, 50hp better than the ZL1 pump.
Forum: Forced Induction - V8 08-15-2022, 01:08 PM
Replies: 22
Views: 2,181
Posted By dreksnot
Ok. I have been trying to avoid using meth for...

Ok. I have been trying to avoid using meth for years. When running my SBE LS3, I relaxed my spark reduction table (IAT Spark Advance Correction - Add) so that the ECU would not start pulling timing...
Forum: Forced Induction - V8 08-15-2022, 12:32 PM
Replies: 22
Views: 2,181
Posted By dreksnot
MAP and MAF different. The MAF is usually about...

MAP and MAF different. The MAF is usually about 18" upstream of the throttle body. Many inject meth about 6" before the throttle body which would be after the IAT sensor so one couldn't see the...
Forum: Forced Induction - V8 08-15-2022, 11:28 AM
Replies: 22
Views: 2,181
Posted By dreksnot
IAT sensor and location are important. Did you...

IAT sensor and location are important. Did you separate and relocate it from the MAF? Choose and using a different sensor (e.g., Rife)?
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 09:59 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2022, vBulletin Solutions, Inc.