Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Vararam
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 500
Search took 0.07 seconds.
Search: Posts Made By: FlukeSS
Forum: 2016+ Camaro: 6th Gen Camaro general forum Yesterday, 11:27 AM
Replies: 55
Views: 4,198
Posted By FlukeSS
I've done a few runs off idle, but seems the car...

I've done a few runs off idle, but seems the car likes 1500 the most so far. I'll keep trying off idle, 1500 and 2000 just to get more consistent data.

Trying to see which of the launch rpm's...
Forum: 2016+ Camaro: 6th Gen Camaro general forum Yesterday, 11:04 AM
Replies: 55
Views: 4,198
Posted By FlukeSS
I hit throttle to 100% before that, You can see...

I hit throttle to 100% before that, You can see below I was at 100% throttle at 2mph, but the actual throttle was at 92.5% So I imagine that is the electronic being slow I guess.
...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-19-2024, 09:26 PM
Replies: 55
Views: 4,198
Posted By FlukeSS
It is aluminum but I felt the tube after a run,...

It is aluminum but I felt the tube after a run, and it was barely warm.

Also the CAI I have isn't the best as I'm learning. There's a lot of engine heat that can get into my intake. Rotofab...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-19-2024, 08:48 PM
Replies: 55
Views: 4,198
Posted By FlukeSS
Ya so far for me it does hit 100% throttle at...

Ya so far for me it does hit 100% throttle at 6mph now, I was light footing it before. But trying to get that down below 6mph seems to be near impossible and may have to do with throttle response I...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-14-2024, 11:27 PM
Replies: 55
Views: 4,198
Posted By FlukeSS
Will be going to the drag strip again this...

Will be going to the drag strip again this Wednesday. Test out the new tune, and try to work in a 2000-2200 rpm stall on launch.

Apparently my car was peaking on hp at about 525 hp, with the...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-14-2024, 10:54 PM
Replies: 13
Views: 1,045
Posted By FlukeSS
Well feel free to remove the thread then, no...

Well feel free to remove the thread then, no reason for it to clutter up the forums.

:noidea:
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-14-2024, 08:39 AM
Replies: 13
Views: 1,045
Posted By FlukeSS
Fair enough then

Fair enough then
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-13-2024, 11:21 PM
Replies: 13
Views: 1,045
Posted By FlukeSS
Is it me?

Or does the 2025 Chevy Nova SS look like a Camaro reskin?

EtkEbVoAtss?si=vXHju9Wv4OdIw8Jp
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-12-2024, 07:25 PM
Replies: 16
Views: 794
Posted By FlukeSS
Am I the only one who wants to poke it with a...

Am I the only one who wants to poke it with a stick?
Forum: General Automotive + Other Cars Discussion 05-09-2024, 12:40 PM
Replies: 84
Views: 4,061
Posted By FlukeSS
No you can blame the dealers for that one. ...

No you can blame the dealers for that one.

We go to buy a V8 car, and they try to sell us a malibu, suggesting its the same thing. Go ahead ask me how many times this has happened to me. And...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-09-2024, 12:29 PM
Replies: 55
Views: 4,198
Posted By FlukeSS
That happens between 2000-2500 rpm, Stock...

That happens between 2000-2500 rpm, Stock torque converter, but the car seems to respond well at 1500 rpm brake torqueing, I was thinking the same thing as you, try to stall it higher around 2000...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-09-2024, 08:51 AM
Replies: 5
Views: 419
Posted By FlukeSS
There is a recall with this but for some reason...

There is a recall with this but for some reason does not include the Camaro SS. Internet is littered with this complaint for camaro ss. Kinda bothersome. Right now I feel like I'm playing Russian...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-08-2024, 09:06 PM
Replies: 55
Views: 4,198
Posted By FlukeSS
Went to the drag strip again got 3 runs in. All...

Went to the drag strip again got 3 runs in. All the shift points were raised, airflow adjusted, timing adjusted, among other things.

According to the original logs, Apparently the tune I got...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-05-2024, 11:42 AM
Replies: 55
Views: 4,198
Posted By FlukeSS
TCM was unlocked and reprogrammed by Shane, but...

TCM was unlocked and reprogrammed by Shane, but its still a T93, so not a T87A swap. But once it is reprogrammed it becomes locked again. So I'm under the impression HP tuner credits to readjust...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-05-2024, 11:37 AM
Replies: 55
Views: 4,198
Posted By FlukeSS
I use either double tap (ESC Comp mode +...

I use either double tap (ESC Comp mode + stabilitrak on) or 10 second off everything off.

I've been using double tap mostly being newer to drag racing and for safety reasons.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-05-2024, 10:21 AM
Replies: 55
Views: 4,198
Posted By FlukeSS
1. Yes I think I am still driving it as if I'm on...

1. Yes I think I am still driving it as if I'm on street tires. Next time out, going to 0-100% throttle instantly, and Yolo it.

2. Talking with someone now about increasing the shift points. He...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-03-2024, 12:08 AM
Replies: 9
Views: 689
Posted By FlukeSS
315/30R20's Did you need a spacer for them? ...

315/30R20's Did you need a spacer for them? Lethal Garage had to move his wire harness with his and used a 5mm spacer, but he may have been using 315/35's don't remember. And yes, the Non 1LE...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-02-2024, 03:43 PM
Replies: 55
Views: 4,198
Posted By FlukeSS
As far as the launch two things: I agree...

As far as the launch two things:

I agree that I might be driving as if I'm on street tires still.

The cone is because I am in the staging lanes for street tires, when I checked in the guy did...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-02-2024, 11:32 AM
Replies: 9
Views: 689
Posted By FlukeSS
In that case, stick with your 1LE stock wheels. ...

In that case, stick with your 1LE stock wheels. You can fit 305/30R20 no problem on the back without rubbing, and 285/30R20's on the front.

I have a non 1LE car myself and I use the 1LE wheels...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-02-2024, 10:43 AM
Replies: 9
Views: 689
Posted By FlukeSS
Depends on which wheel and which ZL1 they came...

Depends on which wheel and which ZL1 they came from.

The non 1LE wheels are 305/30R20 in the back, the 1LE's are:

2021 Chevrolet Camaro ZL1 with 1LE Package Front: 305/30R19, Rear: 325/30R19
...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-02-2024, 10:40 AM
Replies: 55
Views: 4,198
Posted By FlukeSS
After talking to my tuner, I believe I am using...

After talking to my tuner, I believe I am using a conservative tune. Not a max effort tune.

So waiting to hear from a couple of people on here about what ideas they may have regarding the tune,...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-01-2024, 11:30 PM
Replies: 55
Views: 4,198
Posted By FlukeSS
Update: Went to the strip again today to try a...

Update: Went to the strip again today to try a few things

1. My car does not like 20 PSI warm tire pressure. Ended up dropping it to 17-18 PSI Warm
2. Tried launching from Idle and from 1500...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-01-2024, 08:46 AM
Replies: 55
Views: 4,198
Posted By FlukeSS
Well either way I am probably going to the strip...

Well either way I am probably going to the strip later today. Get some new fresh logs.

Fixed TC issue with the new front tires
Will try launching from idle
See if anything changes
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-01-2024, 08:36 AM
Replies: 59
Views: 3,570
Posted By FlukeSS
Indeed, that's pretty much what I was trying to...

Indeed, that's pretty much what I was trying to say. Sometimes don't always word it right.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-30-2024, 07:15 PM
Replies: 59
Views: 3,570
Posted By FlukeSS
No no they won't rub, but the rim lip sticks out...

No no they won't rub, but the rim lip sticks out past the tire width.

As seen in the pictures of my car. I had 275/30R20 Advan V105's originally. Then switched to 285/35R20. (285's fit better...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-30-2024, 07:04 PM
Replies: 59
Views: 3,570
Posted By FlukeSS
Well I ran Advan V105's on the front on the same...

Well I ran Advan V105's on the front on the same rim 275/30R20 Now Atturo AZ850's 285/35R20.

I think you can still do the 30's as that actually lowers the tire height and thus less chance to rub...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-30-2024, 01:28 PM
Replies: 59
Views: 3,570
Posted By FlukeSS
Technically yes, the tire width is almost 1 full...

Technically yes, the tire width is almost 1 full centimeter less than 285's, so higher aspect would be ok in that case. But the problem on 10" wheels is the wheel rim is over the lip of the tire,...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-30-2024, 01:11 PM
Replies: 59
Views: 3,570
Posted By FlukeSS
The OEM offset on 10" rims is 20 not 25. OEM...

The OEM offset on 10" rims is 20 not 25. OEM offset 25 is for 8.5" front wheels not 10". And your 23 offset is right at the maximum aspect ratios at 285 wide. I'm running 285/35R20 on my front...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-30-2024, 10:33 AM
Replies: 55
Views: 4,198
Posted By FlukeSS
I am not sure anymore tbh. I was told they would...

I am not sure anymore tbh. I was told they would need to tune the trans for the cam, but if you are saying they are stock shift points. I dunno anymore.

Not sure about the valve train. Sent...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-29-2024, 05:43 PM
Replies: 55
Views: 4,198
Posted By FlukeSS
Well I'm not to sure about that because the cam...

Well I'm not to sure about that because the cam tops out at 7000, and there's always overplay in the shift I know on the 3rd and 4th gear it shifts at 6500 but doesn't hit over 6600.

I've seen on...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 02:00 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.