Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Vararam
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 366
Search took 0.03 seconds.
Search: Posts Made By: fz4k98
Forum: 5th Gen Camaro SS LS LT General Discussions Yesterday, 08:56 AM
Replies: 39
Views: 988
Posted By fz4k98
I make sure to clean it up well, wipe down all...

I make sure to clean it up well, wipe down all rubber weatherstrips, take one last long ride to burn off any condensation, top off the fuel (not stabilizer) and put a trickle charger on it.

It...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-24-2021, 07:57 AM
Replies: 5
Views: 280
Posted By fz4k98
I have had McLeod twin, Mantic twin and now a...

I have had McLeod twin, Mantic twin and now a Spec 3+ single on a car with 610rwhp.

On my car, the McLeod had a vibration from 1400 to 1700 rpm that they would not warranty.
The Mantic only made...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-21-2021, 07:43 AM
Replies: 4
Views: 245
Posted By fz4k98
tire choice will be a big factor. If tires are...

tire choice will be a big factor. If tires are spinning they are also limiting the stress on the driveline. I didnt have driveline issues until i started running street slicks.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-09-2021, 09:47 PM
Replies: 15
Views: 600
Posted By fz4k98
There should be some witness marks or grind marks...

There should be some witness marks or grind marks on the flexplate gear to point toward the issue. Can you get pics of the flexplate damage?

Visualize a quarter, damage on the knurling of the edge...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-09-2021, 09:32 PM
Replies: 22
Views: 5,236
Posted By fz4k98
You need to provide better detail on the noise,...

You need to provide better detail on the noise, moving, not moving, speed, warm or cold, only in certain gear, certain rpm etc. The manual trans cars have a trans cooler on them and i have never...
Forum: Forced Induction - V8 09-08-2021, 09:18 PM
Replies: 6
Views: 305
Posted By fz4k98
I have tried mickey thompson et street, nitto...

I have tried mickey thompson et street, nitto 555r and have had mixed results. The tires need to be heated up for them to hook in 1st gear. This summer i put on double adjustable rear shocks and...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-08-2021, 08:05 AM
Replies: 15
Views: 600
Posted By fz4k98
To help figure it out you could measure the...

To help figure it out you could measure the flexplate wobble of the current flexplate before taking it apart by rotating the engine while using a dial indicator. Mark the current flexplate location...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-08-2021, 07:54 AM
Replies: 15
Views: 600
Posted By fz4k98
"they think there is a wobble " is not something...

"they think there is a wobble " is not something i would use for deciding. If there is an issue with the crankshaft wobbling they would be able to measure it with dial indicators.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-31-2021, 07:27 AM
Replies: 5
Views: 436
Posted By fz4k98
If no one has inventory the other option may be...

If no one has inventory the other option may be to find a junkyard/auto recycling center and see if they have one in good condition.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-30-2021, 09:20 PM
Replies: 5
Views: 436
Posted By fz4k98
google the part number and you will see options.

google the part number and you will see options.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-26-2021, 08:43 PM
Replies: 9
Views: 447
Posted By fz4k98
Drain the trans before removing. Add a remote...

Drain the trans before removing.
Add a remote slave cylinder bleed line to the slave before installing to help bleed the clutch system.

I split the body and frame to gain enough clearance for the...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-25-2021, 08:29 AM
Replies: 13
Views: 966
Posted By fz4k98
I am seeing this trend in every area of commerce....

I am seeing this trend in every area of commerce. Restaurants only open certain days or hours, home maintenance companies (landscaping, concrete work etc.) booked into next year and on and on.
...
Forum: Forced Induction - V8 08-05-2021, 08:21 AM
Replies: 16
Views: 1,422
Posted By fz4k98
I was having trouble with this until i switched...

I was having trouble with this until i switched to adjustable rear shocks. What a difference. i can dial in anywhere from 1st gear acting like in a rains storm and having to pedal to full hookup.
Forum: 5th Gen Camaro SS LS LT General Discussions 08-04-2021, 11:29 AM
Replies: 6
Views: 411
Posted By fz4k98
I used to not be concerned with following torque...

I used to not be concerned with following torque specs. to much on vehicles and cycles until my career had me learn the details related to the different torque methods and reasons.

Long story...
Forum: Suspension / Brakes / Chassis 08-03-2021, 02:53 PM
Replies: 10
Views: 706
Posted By fz4k98
if your talking about the large cup that holds...

if your talking about the large cup that holds the bushing, good luck. Mine was damaged and dealer said i had to order the entire cradle to get one as it is part of the component.

They said to try...
Forum: Forced Induction - V8 08-03-2021, 02:46 PM
Replies: 16
Views: 1,422
Posted By fz4k98
30k + on my whipple and if the tune is good you...

30k + on my whipple and if the tune is good you dont even know its there unless you get on it.

appears to be solid as i have bounced it off the rev limiter several times with no issues. As for...
Forum: Wheels / Tires 08-02-2021, 06:11 PM
Replies: 12
Views: 618
Posted By fz4k98
typically steering shake is from front and...

typically steering shake is from front and feeling vibration in floor or seat is rear. this may help isolate it.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 08-01-2021, 10:24 PM
Replies: 15
Views: 3,002
Posted By fz4k98
use the clutch engagement point for reference....

use the clutch engagement point for reference. You mention the temperature as a contributor. How far does the pedal travel before the clutch starts to move the car when cold and hot. Also, how far...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-25-2021, 08:23 AM
Replies: 56
Views: 4,556
Posted By fz4k98
I have had cars that were paid off in the past...

I have had cars that were paid off in the past but this camaro doesnt ever seem to be "paid off" The loan is gone but there is still an annual cost for mods, broken parts and tires.

Does this mean...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-24-2021, 08:37 AM
Replies: 56
Views: 4,556
Posted By fz4k98
"blackjack, hookers and camaros just may be the...

"blackjack, hookers and camaros just may be the definition of "proper thinking":smiling1:
Forum: 5th Gen Camaro SS LS LT General Discussions 07-22-2021, 08:45 PM
Replies: 56
Views: 4,556
Posted By fz4k98
Congrats on paying off the loan. Loans are...

Congrats on paying off the loan. Loans are neither good or bad, it depends on how you fit it into your total financial plan. If I can find a vehicle loan at 3 percent or take out some of my money...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-22-2021, 08:16 AM
Replies: 17
Views: 1,061
Posted By fz4k98
It may be different based on model year. My 13...

It may be different based on model year. My 13 has not had tpms sensors for about 5 years and holding the button down until both lights light up works for me.
Forum: 5th Gen Camaro SS LS LT General Discussions 07-22-2021, 08:09 AM
Replies: 8
Views: 711
Posted By fz4k98
If the clutch package including flywheel gets...

If the clutch package including flywheel gets noticeably lighter you will need to have access to a good tuner to help with potential idle issues. I have had the same custom tune on three different...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-21-2021, 08:12 AM
Replies: 8
Views: 711
Posted By fz4k98
I have had 2 twin disk clutch setups and now have...

I have had 2 twin disk clutch setups and now have a spec 3+ single disk. There is a noticeable difference on how a single disk drives vs the twin disk.

The spec drives like a factory clutch and...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-20-2021, 08:15 AM
Replies: 23
Views: 1,480
Posted By fz4k98
As others have mentioned, used car prices are...

As others have mentioned, used car prices are crazy currently. I would not be buying one in the current market unless you will not be concerned by the depreciation in the next few years. Take time,...
Forum: Forced Induction - V8 07-15-2021, 08:06 AM
Replies: 24
Views: 1,278
Posted By fz4k98
The information here says it is fine throughout...

The information here says it is fine throughout and 10 seconds after a run it jumps open almost immediately. What is jumping open?

Are you doing an engine runnning cooldown to normal temp or...
Forum: Forced Induction - V8 07-14-2021, 07:55 PM
Replies: 24
Views: 1,278
Posted By fz4k98
You mention that after burping the system it is...

You mention that after burping the system it is fine. You should jot down exactly what the conditions and amount of time is to narrow it down.

If after a 5 second pull and it is overheating, does...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-29-2021, 08:06 AM
Replies: 22
Views: 2,023
Posted By fz4k98
You may be able to use the previous time slips vs...

You may be able to use the previous time slips vs the latest to get some clues. Compare the different time zones 60ft, 1/8th mile etc. to see where it was slower. Compare the amount of time spent in...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-27-2021, 10:08 PM
Replies: 4
Views: 532
Posted By fz4k98
I have had Mcleod, Mantic and now Spec. The...

I have had Mcleod, Mantic and now Spec. The Mcleod and Mantic were twin disk and the Spec is a single disk. On mine, the Mcleod had vibration issue that could not be resolved and I had to stay away...
Forum: Suspension / Brakes / Chassis 06-20-2021, 08:06 PM
Replies: 16
Views: 1,173
Posted By fz4k98
i have had luck in the past with stuck parts by...

i have had luck in the past with stuck parts by applying the pressure to pull it and then tap around the side of the part lightly with a hammer. The harmonic of the tapping caused the part to jump a...
Showing results 1 to 30 of 366

 
Forum Jump

All times are GMT -5. The time now is 02:30 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2021, vBulletin Solutions, Inc.