Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
TireRack
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 500
Search took 0.06 seconds.
Search: Posts Made By: lincoln361
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment Yesterday, 07:54 PM
Replies: 5
Views: 255
Posted By lincoln361
Can you run e85 with this fuel pump?

Can you run e85 with this fuel pump?
Forum: Forced Induction - V8 11-24-2018, 07:15 PM
Replies: 5
Views: 310
Posted By lincoln361
10-4. Thank you for your response. Nobody really...

10-4. Thank you for your response. Nobody really explained it like that to me. Single is actually a lil cheaper as well. Time to go look for some deals
Forum: Forced Induction - V8 11-24-2018, 10:35 AM
Replies: 5
Views: 310
Posted By lincoln361
I was told to go dual for a force induction. Any...

I was told to go dual for a force induction. Any reason why to go single? Thanks for replying. Just curious.
Forum: Forced Induction - V8 11-17-2018, 09:07 AM
Replies: 5
Views: 310
Posted By lincoln361
TvS2300 Maggie jack shaft catch cans

What are type of catch cans are yall using. Running about 12lbs boost and probably would need the dual cable catch can, but I don't see that many instructions for an install with Maggie blowers so...
Forum: Forced Induction 11-10-2018, 11:51 AM
Replies: 6
Views: 484
Posted By lincoln361
Pm sent

Pm sent
Forum: Forced Induction 11-09-2018, 07:46 AM
Replies: 6
Views: 484
Posted By lincoln361
PM sent

PM sent
Forum: Forced Induction 11-02-2018, 10:38 PM
Replies: 6
Views: 484
Posted By lincoln361
Got a pic of the coil covers?

Got a pic of the coil covers?
Forum: Forced Induction 07-30-2018, 05:36 PM
Replies: 3
Views: 505
Posted By lincoln361
Must of called when i was walking inside the...

Must of called when i was walking inside the plant. I dont get cell service so i didnt see a miss call from anyone.
Forum: Forced Induction - V8 07-29-2018, 09:51 PM
Replies: 15
Views: 1,440
Posted By lincoln361
oh yeah, you will need to swap or grind down on...

oh yeah, you will need to swap or grind down on the passenger fuel rail so the 36mm cog pulley will fit
Forum: Forced Induction - V8 07-29-2018, 09:49 PM
Replies: 15
Views: 1,440
Posted By lincoln361
Little increase in boost with with OD drive cog...

Little increase in boost with with OD drive cog belt with the 3.8 pulley. The noise of the cog belt can belt can be adjusted a little. The tighter the belt the louder the noise will be. I did switch...
Forum: Forced Induction - V8 07-29-2018, 09:38 PM
Replies: 6
Views: 259
Posted By lincoln361
I dont clean mine that often either. I run 25-35%...

I dont clean mine that often either. I run 25-35% of it with dexcool 50/50 and the rest with distilled water.
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 07-10-2018, 05:23 PM
Replies: 2
Views: 117
Posted By lincoln361
Pm sent

Pm sent
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 07-10-2018, 01:14 PM
Replies: 2
Views: 117
Posted By lincoln361
Smile Wtb: Varimax Pump

Like the title states, looking to buy a new/ used varimax pump
Forum: Forced Induction 02-15-2018, 03:28 PM
Replies: 10
Views: 1,250
Posted By lincoln361
bump

bump
Forum: Forced Induction 01-16-2018, 02:27 PM
Replies: 10
Views: 680
Posted By lincoln361
Got pics?

Got pics?
Forum: Forced Induction - V8 10-19-2017, 09:03 PM
Replies: 16
Views: 1,685
Posted By lincoln361
Havnt done any dyno pulls or any 1/4 mile runs...

Havnt done any dyno pulls or any 1/4 mile runs yet. I just did the install and charged the system. Tested to make sure the competetion switch worked. I drove around town and got on the freeway. I had...
Forum: Forced Induction - V8 10-19-2017, 07:05 PM
Replies: 16
Views: 1,685
Posted By lincoln361
Update: I have gotten the chiller installed and i...

Update: I have gotten the chiller installed and i took plently of pics. Its going to take me a while to upload and do a write up of everything. i also got to finish wrapping the rest of the ac lines...
Forum: Forced Induction - V8 10-17-2017, 08:52 AM
Replies: 16
Views: 1,685
Posted By lincoln361
Email sent

Email sent
Forum: Forced Induction - V8 10-15-2017, 01:34 AM
Replies: 16
Views: 1,685
Posted By lincoln361
Yeah i got the same details as far as the...

Yeah i got the same details as far as the instructions goes. He told me over the phone, that from the resevoir it should be routed to the supercharger inlet, not from the chiller. I sent him the...
Forum: Forced Induction - V8 10-14-2017, 03:12 AM
Replies: 16
Views: 1,685
Posted By lincoln361
Active Chiller Install/Review Build on TVS2300 Maggie

I decided that i would try my best to take as many pictures during the install and give my review from the beginning of purchasing it; to the end of the installation as well as what could've been...
Forum: Forced Induction - V8 08-27-2017, 06:34 PM
Replies: 5
Views: 569
Posted By lincoln361
http://www.camaro5.com/forums/showthread.php?t=491...

http://www.camaro5.com/forums/showthread.php?t=491531
Forum: Forced Induction 08-01-2017, 10:43 AM
Replies: 3
Views: 505
Posted By lincoln361
1:1 cog set TVS2300 jackshaft style

Like the title states. Switched to the OD cog set. This 1:1 will give you the whine noise without increasing your boost. Will post pics later but can text me at 361 683 9514. Make me a fair offer...
Forum: Forced Induction 07-28-2017, 10:46 PM
Replies: 6
Views: 1,140
Posted By lincoln361
What size thickness?

What size thickness?
Forum: ZL1 Parts 06-05-2017, 08:43 AM
Replies: 2
Views: 656
Posted By lincoln361
Pm sent

Pm sent
Forum: Transmission / Driveline 06-03-2017, 12:13 PM
Replies: 4
Views: 1,030
Posted By lincoln361
Do you want to sell the stall seperately? What...

Do you want to sell the stall seperately? What are the specs on the stall?
Forum: Forced Induction 06-01-2017, 07:05 PM
Replies: 10
Views: 1,250
Posted By lincoln361
Looking for on like this

Looking for on like this
Forum: Forced Induction 06-01-2017, 11:38 AM
Replies: 10
Views: 1,250
Posted By lincoln361
Pm sent

Pm sent
Forum: Forced Induction 05-31-2017, 01:57 PM
Replies: 10
Views: 1,250
Posted By lincoln361
Yes they are expensive new, kinda hoping that i...

Yes they are expensive new, kinda hoping that i can find something used or semi used. I did find one that a guy was selling on here but he did not have a paypal account. Didnt know how he expected to...
Forum: Forced Induction 05-30-2017, 07:43 PM
Replies: 10
Views: 1,250
Posted By lincoln361
Smile WTB: Nitrous Outlet dedicated standalone

As the title states. Wanting to buy a nitrous outlet stand-alone kit. Not looking for an universal. Want to see if anybody is thinking about know somebody that is selling theres before i pull the...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 05-19-2017, 11:04 AM
Replies: 5
Views: 532
Posted By lincoln361
i have these injectors. Tuner had no problems...

i have these injectors. Tuner had no problems with them. GLWS
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 09:42 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2018, vBulletin Solutions, Inc.