Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Phastek Performance
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 500
Search took 0.09 seconds.
Search: Posts Made By: CamaroCracka
Forum: 5th Gen Camaro SS LS LT General Discussions Yesterday, 05:37 PM
Replies: 1
Views: 115
Posted By CamaroCracka
I once tapped the stock shifter shaft to adapt a...

I once tapped the stock shifter shaft to adapt a Hurst handle. I think I saw it in the DIY section. I used a 14mm tap and a Hurst adapter bushing.
Forum: 5th Gen Camaro SS LS LT General Discussions Yesterday, 05:33 PM
Replies: 16
Views: 384
Posted By CamaroCracka
Tougher to mod too with all that VVT AFM BS.

Tougher to mod too with all that VVT AFM BS.
Forum: 5th Gen Camaro SS LS LT General Discussions Yesterday, 05:27 PM
Replies: 4
Views: 138
Posted By CamaroCracka
You need to pull 2* of timing for every 50hp of...

You need to pull 2* of timing for every 50hp of nitrous you use. I would not think they would drive around with timing pulled in the tune, so he either used two tunes or had another way to pull...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) Yesterday, 11:56 AM
Replies: 0
Views: 86
Posted By CamaroCracka
Better ZL1 Wheel Seal

Is there a better seal for the axles on the ZL1 that the OEM ‎20964013? Twice now, the spring inside the rubber part has come out when I removed the axle. Nobody caries them, they are $50 a piece,...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-18-2021, 06:50 PM
Replies: 14
Views: 413
Posted By CamaroCracka
We discard boards we sell for thousands all the...

We discard boards we sell for thousands all the time. Too difficult to repair multilayered pcb.

Find an electronics guy in Korea or take a look at the board yourself. If it's single layer and you...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-18-2021, 11:21 AM
Replies: 3
Views: 169
Posted By CamaroCracka
https://www.amazon.com/SPEEDWOW-Joint-Exhaust-Slee...

https://www.amazon.com/SPEEDWOW-Joint-Exhaust-Sleeve-Stainless/dp/B07S1NSVB6/ref=asc_df_B07S1NSVB6?tag=bingshoppinga-20&linkCode=df0&hvadid=80264429311077&hvnetw=o&hvqmt=e&hvbmt=be&hvdev=c&hvlocint=&h...
Forum: Forced Induction - V8 06-17-2021, 07:54 AM
Replies: 5
Views: 267
Posted By CamaroCracka
Here is what Walbro had to say. Looks like the...

Here is what Walbro had to say. Looks like the height of the bucket, or lack there of, is what makes our fuel systems hard to modify.

1. Yes the F90000285 pump can be used in a PWM system.
2. We...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-17-2021, 07:03 AM
Replies: 14
Views: 413
Posted By CamaroCracka
Nobody has repaired circuit boards for decades....

Nobody has repaired circuit boards for decades. Too cheap to just replace them with new.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 06-16-2021, 03:54 PM
Replies: 4
Views: 213
Posted By CamaroCracka
Apparently, autos love DRs but they are no bueno...

Apparently, autos love DRs but they are no bueno for sticks.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 06-15-2021, 09:16 AM
Replies: 4
Views: 213
Posted By CamaroCracka
2.0 on the DRs. First run on slicks broke the...

2.0 on the DRs. First run on slicks broke the axle.
Forum: Forced Induction - V8 06-15-2021, 08:37 AM
Replies: 5
Views: 267
Posted By CamaroCracka
It's supposed to be pulse width modulated, but it...

It's supposed to be pulse width modulated, but it has a couple bad reviews on Summit and people say it runs hot.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-15-2021, 07:34 AM
Replies: 2
Views: 156
Posted By CamaroCracka
Monster and Tick both sell a billet bearing...

Monster and Tick both sell a billet bearing support. Put that in the new slave before you install it.
Forum: Forced Induction - V8 06-14-2021, 12:01 PM
Replies: 5
Views: 267
Posted By CamaroCracka
Anyone Used a Hellcat Pump in a Stock Hat

Was reading another thread and the OP talked about using Hellcat pumps, so I Googled it and looks very similar to a ZL1 pump. Seems like a $200 returnless pump with roughly twice the capacity of a...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-13-2021, 01:29 PM
Replies: 13
Views: 328
Posted By CamaroCracka
I'm not getting why you have to resleeve all the...

I'm not getting why you have to resleeve all the bores and not just the one. I dropped a valve on a 427 last year and the machine shop just pulled that sleeve and put a new one in. I did have to put...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 06-12-2021, 01:11 PM
Replies: 4
Views: 213
Posted By CamaroCracka
Broken ZL1 Axle

I broke a ZL1 axle last Sunday and thought it might be useful for some to know the circumstances. With the help of some of they guys on the forum, I was able to get the car to launch hard by setting...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 06-11-2021, 03:53 PM
Replies: 16
Views: 834
Posted By CamaroCracka
You will be much happier with a dead battery than...

You will be much happier with a dead battery than if something happens to your car while your neighbor is driving it, even if it's not your neighbors fault.
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 06-11-2021, 06:24 AM
Replies: 6
Views: 391
Posted By CamaroCracka
For 1k, you can probably find a set of mint stock...

For 1k, you can probably find a set of mint stock wheels.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-10-2021, 08:23 AM
Replies: 11
Views: 622
Posted By CamaroCracka
When I put my ported TB on years ago, I got on it...

When I put my ported TB on years ago, I got on it and it went straight to limp mode, so the ECM seeing something it is not expecting in relation to the MAF and RPM can certainly put it in limp mode.
Forum: 5th Gen Camaro SS LS LT General Discussions 06-10-2021, 07:26 AM
Replies: 35
Views: 1,059
Posted By CamaroCracka
I would not run a mix of E85 without the...

I would not run a mix of E85 without the composition sensor, but from what I've read, which is a good bit, the ECM is capable of compensating for about an 80/20 mix. Anything higher, you will be...
Forum: Suspension / Brakes / Chassis 06-08-2021, 10:57 AM
Replies: 4
Views: 281
Posted By CamaroCracka
If they are Brembos, there is a pin holding them...

If they are Brembos, there is a pin holding them in. They can't even fall out. Get some bailing wire to hang them. Every time I put a block under a caliper to hold it up, I knock the block over and...
Forum: Suspension / Brakes / Chassis 06-08-2021, 10:53 AM
Replies: 10
Views: 393
Posted By CamaroCracka
I used a long 3/4" bolt, washers and the steel...

I used a long 3/4" bolt, washers and the steel insert. Like Hester said, I put tops in first. The holes were pretty clean and they pulled right in with an old impact I use for situation requiring...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-08-2021, 10:37 AM
Replies: 16
Views: 787
Posted By CamaroCracka
If you live in Florida, you technically only have...

If you live in Florida, you technically only have one season, summer.

The oil is designed to be good well over 240, but running 5w40 is not going to do any harm and it will give a little bit more...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-07-2021, 03:20 PM
Replies: 16
Views: 787
Posted By CamaroCracka
You would usually not need anything other than...

You would usually not need anything other than Mobil1 unless you track it, but 240 after a few pulls would bother me too. When you say pulls, you mean quarter mile runs right?
Forum: 5th Gen Camaro SS LS LT General Discussions 06-07-2021, 03:13 PM
Replies: 13
Views: 668
Posted By CamaroCracka
I have a Z28 suspension and 305s on the front....

I have a Z28 suspension and 305s on the front. Plus the tires are super sticky (<180 treadwear) and I have the FE4 conversion with 25/28mm bars. I'm really not good enough at road racing to say how...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-03-2021, 02:17 PM
Replies: 13
Views: 668
Posted By CamaroCracka
I run 325/30VR20s on 20x11 ZL1 wheels with no...

I run 325/30VR20s on 20x11 ZL1 wheels with no issues.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 05-31-2021, 01:56 PM
Replies: 8
Views: 282
Posted By CamaroCracka
CSC is the concentric slave cylinder. I would not...

CSC is the concentric slave cylinder. I would not try to replace the seal. Just put a new one in. Most of the aftermarket clutches I have seen use the factory slave cylinders, they just provide a new...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 05-27-2021, 11:46 AM
Replies: 8
Views: 282
Posted By CamaroCracka
I'm assuming you have a separate clutch...

I'm assuming you have a separate clutch reservoir, and if you flushed to clean fluid and already have that much dust back in the fluid, there has to be an issue with the CSC seal.
Forum: 5th Gen Camaro SS LS LT General Discussions 05-26-2021, 10:17 AM
Replies: 39
Views: 2,157
Posted By CamaroCracka
If it's stock, it's 192* They do sell an number...

If it's stock, it's 192* They do sell an number of variations between 192 and 160, but the only way I know to tell is take it out and put it in hot water with a thermometer. I would not worry about...
Forum: Suspension / Brakes / Chassis 05-25-2021, 03:33 PM
Replies: 20
Views: 588
Posted By CamaroCracka
Correct.

Correct.
Forum: Suspension / Brakes / Chassis 05-25-2021, 02:03 PM
Replies: 20
Views: 588
Posted By CamaroCracka
Yup, that second pic is the deal. SS hubs don't...

Yup, that second pic is the deal. SS hubs don't have much of that taper area. I'm not sure the $50 versions are the ones you want if you are looking for longevity. There are some big power guys who...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 03:56 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2021, vBulletin Solutions, Inc.