Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Phastek Performance
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 495
Search took 0.05 seconds. Search: Posts Made By: G8One2
Forum: Tuning / Diagnostics -- engine and transmission 09-27-2021, 11:26 AM
Replies: 5
Views: 1,919
Posted By G8One2
Probably had headers on it at one time, and never...

Probably had headers on it at one time, and never had the stock tune put back to stock. I'd check that with someone who has HP Tuners
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-26-2021, 04:47 PM
Replies: 18
Views: 3,881
Posted By G8One2
Tip heights can vary .025" or so from valve to...

Tip heights can vary .025" or so from valve to valve (on stock heads / valve seats). They're also different bank to bank. I suspect this is why the OEM run .070" or more pre load, to take up that...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-25-2021, 07:27 PM
Replies: 47
Views: 7,980
Posted By G8One2
If it throws anything, it will be a catalysts...

If it throws anything, it will be a catalysts efficiency code.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-25-2021, 05:19 PM
Replies: 47
Views: 7,980
Posted By G8One2
I have Kooks LT, high flow cats and NPP exhaust....

I have Kooks LT, high flow cats and NPP exhaust. I feel no need to change it. Sounds good to me and not too terribly loud when putzing around.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 09-25-2021, 02:19 PM
Replies: 7
Views: 1,736
Posted By G8One2
Yep, you'll have to reinstall all the original...

Yep, you'll have to reinstall all the original stuff, wait for it to pass THEN disable the fault codes and set them to no error reported. Jot all the fault down before hand, so you know what ones to...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 09-25-2021, 09:39 AM
Replies: 10
Views: 6,150
Posted By G8One2
I would also suggest using an OEM part from the...

I would also suggest using an OEM part from the dealer for stuff like this, and not your local Auto Zone or whatever. Idk where you got the part from, but you could be chasing your tail using...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 09-25-2021, 09:34 AM
Replies: 10
Views: 6,150
Posted By G8One2
Oops my bad, he meant PO335 not the other one....

Oops my bad, he meant PO335 not the other one. Yep circuit needs checked
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 09-25-2021, 09:30 AM
Replies: 10
Views: 6,150
Posted By G8One2
Isnt PO355 a coil fail not the crank sensor? If...

Isnt PO355 a coil fail not the crank sensor? If the crank sensor circuit was faulted, it wouldn't fire at all.
Forum: 5th Gen Camaro SS LS LT General Discussions 09-25-2021, 09:25 AM
Replies: 5
Views: 1,860
Posted By G8One2
This happens to me occasionally when I unplug my...

This happens to me occasionally when I unplug my MPVI2 when the vehicle is running. I sometimes forget to disconnect the software from the vehicle before unplugging it. It tends to fault out my ABS,...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 09-25-2021, 09:13 AM
Replies: 7
Views: 1,736
Posted By G8One2
Another thing to note, if you want it to pass...

Another thing to note, if you want it to pass emissions. You needed to disable the codes prior to the mods, or prior to the codes settings. If you catch them as pending, and then disable them you're...
Forum: Tuning / Diagnostics -- engine and transmission 09-25-2021, 09:07 AM
Replies: 16
Views: 5,068
Posted By G8One2
Higher pressures make your injectors flow more,...

Higher pressures make your injectors flow more, if your fuel pump can keep up. I've got mine running 60psi at the rail. My injectors are 65lb/hr at 38psi and 80lb/hr at 60psi. No, I dont really need...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-24-2021, 08:42 AM
Replies: 60
Views: 8,357
Posted By G8One2
Drive mine year round, even occasionally in 12"...

Drive mine year round, even occasionally in 12" of snow. Get yourself a good set of Blizzak tires and drive her.
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 09-24-2021, 08:38 AM
Replies: 7
Views: 1,863
Posted By G8One2
Tire pressures stated in the door are based off...

Tire pressures stated in the door are based off of GVW. This weight is set as a fully loaded vehicle with passengers and cargo. So setting your pressures to 36psi like it says in the door will be...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-23-2021, 07:02 PM
Replies: 5
Views: 1,860
Posted By G8One2
If you have anything plugged into the OBD port,...

If you have anything plugged into the OBD port, thats there all the time, remove it.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 09-23-2021, 07:00 PM
Replies: 4
Views: 1,021
Posted By G8One2
Thats an o2 sensor connector. The downstream...

Thats an o2 sensor connector. The downstream sensor connectors are not that shape, and the pigtails come out of the harness down by the sides of the transmission.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-23-2021, 04:38 PM
Replies: 7
Views: 1,094
Posted By G8One2
It also sometimes helps, to push IN on the whole...

It also sometimes helps, to push IN on the whole connector before depressing the white tab, then pulling it off. The white locking tab can sometimes get wedged up against the shoulder it clips over,...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-21-2021, 06:42 PM
Replies: 5
Views: 1,052
Posted By G8One2
You only have to bleed the ABS if your reservoirs...

You only have to bleed the ABS if your reservoirs is empty and you push the brake pedal, thus forcing air into it. Avoid doing that. Pull a vacuum on the reservoir, when half filled with fluid, will...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-20-2021, 05:55 PM
Replies: 17
Views: 2,101
Posted By G8One2
Looks to me the pistons are expanding too much...

Looks to me the pistons are expanding too much from heat in the bore. Which causes the skirts to scuff the cylinder walls. The deeper looking, long one is either debris or a ring end gap starting to...
Forum: Off-topic Discussions 09-19-2021, 08:02 AM
Replies: 885
Views: 204,260
Posted By G8One2
42, prototype vehicle development / BEV-HEC-ICE

42, prototype vehicle development / BEV-HEC-ICE
Forum: Garage / Tools Discussions 09-19-2021, 07:40 AM
Replies: 13
Views: 6,427
Posted By G8One2
The Milwalkee ones are very nice. I have a 3/4"...

The Milwalkee ones are very nice. I have a 3/4" and a 3/8". Very strong, no issues with them.
Forum: Tuning / Diagnostics -- engine and transmission 09-18-2021, 10:08 PM
Replies: 16
Views: 5,068
Posted By G8One2
You may need to copy over the ZL1 parameters in...

You may need to copy over the ZL1 parameters in the FPCM. Then make changes to desired pressure, low flow, high flow and default pressures under the fuel tab.
Forum: Off-topic Discussions 09-18-2021, 08:40 PM
Replies: 415
Views: 110,442
Posted By G8One2
Hahahaha

Hahahaha
Forum: Tuning / Diagnostics -- engine and transmission 09-18-2021, 08:39 PM
Replies: 16
Views: 5,068
Posted By G8One2
The fuel pump itself has an internal regulator...

The fuel pump itself has an internal regulator that won't let it go past 58 psi. You'd need a ZL1 pump or better to run higher pressures. I currently have a ZL1 pump installed and running 60 psi at...
Forum: Off-topic Discussions 09-18-2021, 01:43 PM
Replies: 415
Views: 110,442
Posted By G8One2
https://cimg2.ibsrv.net/gimg/www.corvetteforum.com...

https://cimg2.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/490x544/image_eedea867f9ff93f5ab2f8e43d6073a59c35261a3.png
Forum: Off-topic Discussions 09-18-2021, 01:41 PM
Replies: 415
Views: 110,442
Posted By G8One2
https://1.bp.blogspot.com/-orQ8_iDBWos/YT_fHLV29aI...

https://1.bp.blogspot.com/-orQ8_iDBWos/YT_fHLV29aI/AAAAAAAAyTI/h61Rw1dq1X4JCgTp-fgwsexCmUs8dcHWgCLcBGAsYHQ/w424-h640/813.jpeg
Forum: Off-topic Discussions 09-18-2021, 12:56 PM
Replies: 415
Views: 110,442
Posted By G8One2
I only posted that to illustrate some of the...

I only posted that to illustrate some of the psychology of how people think. Regardless of where you stand on political issues, or over this whole COVID debacle, the psychology behind human emotion...
Forum: Off-topic Discussions 09-18-2021, 09:41 AM
Replies: 415
Views: 110,442
Posted By G8One2
https://www.psychologytoday.com/us/blog/identity-s...

https://www.psychologytoday.com/us/blog/identity-shift/201511/why-people-become-sheeple
Forum: Off-topic Discussions 09-17-2021, 05:43 PM
Replies: 415
Views: 110,442
Posted By G8One2
https://media.gab.com/system/media_attachments/fil...

https://media.gab.com/system/media_attachments/files/084/798/129/original/5493789e0e7a6607.png
Forum: Off-topic Discussions 09-14-2021, 07:00 PM
Replies: 415
Views: 110,442
Posted By G8One2
https://media.gab.com/system/media_attachments/fil...

https://media.gab.com/system/media_attachments/files/084/786/369/original/64bb9aab22f96c20.png
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-14-2021, 05:43 PM
Replies: 55
Views: 9,891
Posted By G8One2
It's not really a wear item, so it shouldn't...

It's not really a wear item, so it shouldn't cause any issues. Only if it were removed and reinstalled and not replaced, or the o-ring tore during installation. If it were in there and no on had...
Showing results 1 to 30 of 495
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 12:30 PM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.