Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Bigwormgraphix
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read


Page 1 of 13 1 234511 Last »
Showing results 1 to 30 of 368
Search took 0.03 seconds. Search: Posts Made By: Medi0cr3
Forum: Tuning / Diagnostics -- engine and transmission 12-01-2014, 11:03 PM
Replies: 34
Views: 4,141
Posted By Medi0cr3
I get 22 mpg with my mods on the highway at 75-80...

I get 22 mpg with my mods on the highway at 75-80 @ 2100 rpm...
15MPG in the city
And I drive like a raging idiot.............
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-29-2014, 11:22 PM
Replies: 6
Views: 2,258
Posted By Medi0cr3
Yep. If you get long tubes it will be pretty damn...

Yep. If you get long tubes it will be pretty damn loud though.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-28-2014, 11:07 PM
Replies: 19
Views: 3,733
Posted By Medi0cr3
I had with mine at the start, but after break-in,...

I had with mine at the start, but after break-in, it was fine. This clutch is a dang good clutch!

If you think its a big issue, pull it back apart and ensure you have the clutch discs facing the...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-28-2014, 12:38 AM
Replies: 7
Views: 1,892
Posted By Medi0cr3
Thanks Bo. That is basically all that I could...

Thanks Bo. That is basically all that I could come up as well with as far as the end items. Do you recommend any specific brands over one another?
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-27-2014, 11:37 PM
Replies: 7
Views: 1,892
Posted By Medi0cr3
TH400 parts list

I'm looking to see if anybody has a basic all inclusive parts list for a TH400 swap from an M6. Recommended parts and vendors would be great. I was looking at ATI transmissions for the built tranny. ...
Forum: Dragstrip and Launch Techniques Discussion 11-26-2014, 08:31 AM
Replies: 67
Views: 22,750
Posted By Medi0cr3
Are you referring to my post or? I'm mainly...

Are you referring to my post or? I'm mainly curious if its over kill or not for a setup like mine.
Forum: Dragstrip and Launch Techniques Discussion 11-26-2014, 07:55 AM
Replies: 67
Views: 22,750
Posted By Medi0cr3
I'm seriously considering doing this with my...

I'm seriously considering doing this with my current setup. I'm looking for traction so bad right now. Anybody have any insight if this will help?
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-25-2014, 11:33 PM
Replies: 28
Views: 10,067
Posted By Medi0cr3
What's the average deficit to the wallet for the...

What's the average deficit to the wallet for the conversion?
Forum: Forced Induction - V8 11-25-2014, 10:12 AM
Replies: 9
Views: 2,147
Posted By Medi0cr3
I don't have much knowledge of the kit, however...

I don't have much knowledge of the kit, however is there any specific reason the kit hasn't come out for the earlier year models other than the power steering pump?
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 11-25-2014, 06:14 AM
Replies: 28
Views: 10,067
Posted By Medi0cr3
I'm also interested in a list for a TH 400...

I'm also interested in a list for a TH 400 install!
Forum: Forced Induction - V8 11-24-2014, 04:20 AM
Replies: 38
Views: 5,382
Posted By Medi0cr3
I got a chuckle out of that...:pound:

I got a chuckle out of that...:pound:
Forum: Forced Induction - V8 11-23-2014, 03:01 PM
Replies: 66
Views: 11,277
Posted By Medi0cr3
I don't know yet, probably something to do with...

I don't know yet, probably something to do with marketing warnings. However, I feel that there is a lot of biased warnings between certain vendors and certain moderators. Especially vendors that...
Forum: Forced Induction - V8 11-23-2014, 02:56 AM
Replies: 4
Views: 2,175
Posted By Medi0cr3
AGP best bet

AGP best bet
Forum: Forced Induction - V8 11-23-2014, 02:39 AM
Replies: 66
Views: 11,277
Posted By Medi0cr3
I made the alignment changes he recommended and...

I made the alignment changes he recommended and I'm very planted now. Even at my power levels and all bmr suspension upgrades, I still smoke the tires. However it's much more streamlined and staying...
Forum: Forced Induction - V8 11-23-2014, 02:20 AM
Replies: 66
Views: 11,277
Posted By Medi0cr3
Alignment? Thomas from H-E gave me the best tip...

Alignment? Thomas from H-E gave me the best tip in the world.

On a side note, it's freaking sad to see him banned instead of Jannetty with the shenanigans between jre and Jamie. :der: Thomas has...
Forum: Forced Induction - V8 11-22-2014, 11:39 PM
Replies: 66
Views: 11,277
Posted By Medi0cr3
I'm more inclined to look at suspension and tire...

I'm more inclined to look at suspension and tire alignment rather than a size or brand of tire. At those power levels, if you don't have the suspension or tire alignment to boot, you will just induce...
Forum: Suspension / Brakes / Chassis 05-26-2014, 04:07 PM
Replies: 18
Views: 3,036
Posted By Medi0cr3
Got it figured out. Rear Left camber eccentric...

Got it figured out. Rear Left camber eccentric was not properly installed during the last alignment.
Forum: Suspension / Brakes / Chassis 05-26-2014, 10:56 AM
Replies: 18
Views: 3,036
Posted By Medi0cr3
I was standing right there. =/

I was standing right there. =/
Forum: Suspension / Brakes / Chassis 05-26-2014, 10:41 AM
Replies: 15
Views: 2,792
Posted By Medi0cr3
^^^^^ Way easier than a sawzaw. Trust me :clap2:

^^^^^
Way easier than a sawzaw. Trust me :clap2:
Forum: Suspension / Brakes / Chassis 05-26-2014, 10:37 AM
Replies: 18
Views: 3,036
Posted By Medi0cr3
The front suspension has never been touched =/...

The front suspension has never been touched =/ Not even for a front alignment.
Forum: Suspension / Brakes / Chassis 05-26-2014, 12:51 AM
Replies: 15
Views: 2,792
Posted By Medi0cr3
The assy is in the instructions. Its fairly...

The assy is in the instructions. Its fairly simple. I had no idea what I was doing either. I guess you can use heat, much easier on the hadns than a sawzaw. fml..
Forum: Suspension / Brakes / Chassis 05-26-2014, 12:40 AM
Replies: 18
Views: 3,036
Posted By Medi0cr3
I wish it did, but it didn't. There's no evidence...

I wish it did, but it didn't. There's no evidence of slippage on the metal. No "clean" area from a steady state. :iono:
Forum: Suspension / Brakes / Chassis 05-25-2014, 11:51 PM
Replies: 18
Views: 3,036
Posted By Medi0cr3
Then explain the camber =/

Then explain the camber =/
Forum: Suspension / Brakes / Chassis 05-25-2014, 11:15 PM
Replies: 18
Views: 3,036
Posted By Medi0cr3
it was perfect alignment in the front before I...

it was perfect alignment in the front before I went to the autocross and afterwards my camber changed significantly more positive if not straight up and down. I didn't even hit a single cone.
Forum: Suspension / Brakes / Chassis 05-25-2014, 10:20 PM
Replies: 15
Views: 2,792
Posted By Medi0cr3
You will definately need a sawzaw

You will definately need a sawzaw
Forum: Suspension / Brakes / Chassis 05-25-2014, 07:41 PM
Replies: 2
Views: 1,178
Posted By Medi0cr3
Ridetech coilovers. Pfadt are great units, but...

Ridetech coilovers. Pfadt are great units, but there's no more warranty work for them and parts to fix them are.. well.. soon to be limited...

Apex has been working with Ridetech and they have...
Forum: Suspension / Brakes / Chassis 05-25-2014, 07:39 PM
Replies: 18
Views: 4,593
Posted By Medi0cr3
I have this all, but the brake conversion package...

I have this all, but the brake conversion package and I'm loving it. Its great at the drag strip, the launch feels so planted! I actually got the rear tires with 0 degrees camber and no more than...
Forum: Suspension / Brakes / Chassis 05-25-2014, 07:33 PM
Replies: 18
Views: 3,036
Posted By Medi0cr3
Bent Front Strut???

Went to the autocross today and had a successful day. However on the ride home I noticed my alignment was mega off. Once I got home, I noticed that the front right had a lot of positive camber and...
Forum: Forced Induction - V6 05-06-2014, 03:25 PM
Replies: 0
Views: 830
Posted By Medi0cr3
seat restraint

Anybody have any good seat restraint systems? I'm looking for a 4 or 5 piece and I'm not opposed to having a restraint bar installed a cross the back of the seats.
Forum: Suspension / Brakes / Chassis 05-03-2014, 10:22 PM
Replies: 24
Views: 3,442
Posted By Medi0cr3
That's what I thought..... lol.. I however need 2...

That's what I thought..... lol.. I however need 2 spanner wrenches for my Strange rear coilovers =/
Showing results 1 to 30 of 368
Page 1 of 13 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 12:31 AM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.