Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
dave@hennessey
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Page 1 of 2 1 2
Showing results 1 to 30 of 60
Search took 0.01 seconds. Search: Posts Made By: SSyclone
Forum: Tuning / Diagnostics -- engine and transmission 07-14-2023, 03:12 PM
Replies: 1
Views: 1,136
Posted By SSyclone
ECM replacement and 30 minute relearn

I had an unfortunate incident after installing my engine, after another unfortunate incident. You play you pay. After reinstalling the motor in my Camaro (the Mechanic, aka Me) did not tighten the...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 07-14-2023, 03:05 PM
Replies: 0
Views: 467
Posted By SSyclone
Ecm replacement 30 minute relearn

I find myself in need of a little assistance with this problem.

I had an unfortunate incident after installing my engine, after another unfortunate incident. You play you pay. After reinstalling...
Forum: Forced Induction - V8 06-17-2022, 09:07 PM
Replies: 8
Views: 2,731
Posted By SSyclone
I know I'm dragging up a year old post. Yes...

I know I'm dragging up a year old post.

Yes I just did this two weeks ago. Is this just a fluke. My car is an 11, lsa conversion etc. I've never even seen a drop of coolant leakage. Then during a...
Forum: Forced Induction - V8 08-09-2021, 11:22 AM
Replies: 17
Views: 5,187
Posted By SSyclone
Id start by scouring the classifieds here. Keep...

Id start by scouring the classifieds here. Keep an open mind and be ready when something you like pops up. These guys change their setups like their underwear.

Whatever you wind up with, when you...
Forum: Forced Induction - V6 01-09-2021, 06:32 PM
Replies: 4
Views: 2,365
Posted By SSyclone
Bit of a late follow up, depending on you level...

Bit of a late follow up, depending on you level of performance, if your going big lose the cats. My opinion of course.

Plus on the gauges is good to be able to look at anything you may need to...
Forum: Forced Induction - V6 01-08-2021, 10:19 PM
Replies: 4
Views: 2,365
Posted By SSyclone
I have a dual set of Aeroforce gauges in a pulsar...

I have a dual set of Aeroforce gauges in a pulsar mount. They'll monitor tons of stuff and display 4 parameters at a time or cycle through.

Check out the Banks I dash, expensive but one wild do...
Forum: Forced Induction - V8 05-01-2020, 06:45 PM
Replies: 0
Views: 527
Posted By SSyclone
2.38 griptec pulley

So who has a ultra tiny 2.38 griptec lsa pulley? How well does it perform form and what boost levels are you getting from it?
Forum: Forced Induction - V8 01-18-2020, 03:51 PM
Replies: 1
Views: 779
Posted By SSyclone
LS3 / W LSA lifter failure

Incase you don't want to read my story, what lifters won't break in a supercharged ls3?

Awhile back some weird crap happened after washing my car, after drying it I did a little hot lap to blow...
Forum: Forced Induction - V8 10-14-2019, 07:16 PM
Replies: 2
Views: 1,258
Posted By SSyclone
I bought charger used 2 years ago, if it's been...

I bought charger used 2 years ago, if it's been done I do not know? I'll find out soon.
I just remember the PCV vent is sticking up from the galley cover. I think that's gonna hose me.
Forum: Forced Induction - V8 10-14-2019, 06:28 PM
Replies: 2
Views: 1,258
Posted By SSyclone
LSA isolator coupling

Well as luck would have it in going to be replacing the isolater in my supercharger.
I'm pretty sure I know the answer to this question but what the hell I'll ask.


Can I get the snout of...
Forum: Suspension / Chassis / Brakes 08-11-2018, 08:57 PM
Replies: 1
Views: 668
Posted By SSyclone
SOLD

SOLD
Forum: Suspension / Chassis / Brakes 08-11-2018, 03:22 PM
Replies: 1
Views: 668
Posted By SSyclone
BMR Rear Toe Rods

Sold
Forum: Forced Induction - V8 07-22-2017, 10:21 AM
Replies: 22
Views: 5,122
Posted By SSyclone
The E force is a nice kit. You'll make a bunch of...

The E force is a nice kit. You'll make a bunch of power and shouldn't have to go through the drive line.

I did the LSA conversion and bought a used kit from a member not a driver so time wasn't...
Forum: Forced Induction - V8 07-21-2017, 09:14 PM
Replies: 12
Views: 2,677
Posted By SSyclone
Titereach

Titereach
Forum: Forced Induction - V8 07-09-2017, 09:01 PM
Replies: 14
Views: 2,194
Posted By SSyclone
Just get the ADM kit and don't look back. The no...

Just get the ADM kit and don't look back. The no cats runs well but it smells like an old musclecar. I get a fair amount of deceleration pop. That's pretty much inherent of a free flowing exhaust.
Forum: Wheels / Tires 07-09-2017, 09:43 AM
Replies: 6
Views: 2,521
Posted By SSyclone
Im interested, sent you a PM

Im interested, sent you a PM
Forum: Forced Induction - V8 07-09-2017, 09:17 AM
Replies: 11
Views: 3,315
Posted By SSyclone
You can get a Schrader adapter, you remove the...

You can get a Schrader adapter, you remove the valve from the fuel rail and either install gauge under the hood or get lines and mount elsewhere.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 07-05-2017, 10:08 PM
Replies: 10
Views: 3,422
Posted By SSyclone
I have a SPEC stage 3+ , it's somewhat firm in...

I have a SPEC stage 3+ , it's somewhat firm in the pedal area. But holds all I can throw at it.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 06-15-2017, 09:24 PM
Replies: 6
Views: 2,105
Posted By SSyclone
I got one of these after installing SPEC clutch...

I got one of these after installing SPEC clutch in my CAMARO. You can adjust it to bring your engagement point closer to the floor. Works well !

You will have to bleed your clutch after...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 05-30-2017, 08:30 PM
Replies: 11
Views: 2,914
Posted By SSyclone
Ram 78180 Jegs & Summit are both at $429...

Ram 78180

Jegs & Summit are both at $429 Summit was less when I bought mine.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 05-27-2017, 08:55 PM
Replies: 11
Views: 2,914
Posted By SSyclone
Ram clutch slave cylinder

Just want to throw a little info out there to anyone looking to replace their slave cylinder. I decided to use the RAM slave set-up during my clutch install. Super nice unit, comes with full...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 05-07-2017, 08:40 PM
Replies: 21
Views: 8,621
Posted By SSyclone
Well just hit the ground Saturday and although I...

Well just hit the ground Saturday and although I have only put about 6 miles on her. I'll say that you'll want to start doing a little leg work at the gym before going with this one. I'm not 100%...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-25-2017, 09:17 PM
Replies: 21
Views: 8,621
Posted By SSyclone
I'm in the midst of putting a Spec Stage 3+ in my...

I'm in the midst of putting a Spec Stage 3+ in my 2011 SS. She's in the air right now. Got a new RAM slave cylinder also. And I'll be isolating the clutch fluid and removing it from the brake...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-05-2017, 05:39 PM
Replies: 11
Views: 2,749
Posted By SSyclone
Got mine from Jegs.

Got mine from Jegs.
Forum: 5th Gen Camaro SS LS LT General Discussions 03-25-2017, 09:50 PM
Replies: 522
Views: 58,203
Posted By SSyclone
There's no way I'm going to spend all night...

There's no way I'm going to spend all night reading this entire 23 page thread. I read the original question, or dilemma, then skimmed through some of the subsequent postings.

Here's how I do...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-03-2017, 08:06 PM
Replies: 2
Views: 945
Posted By SSyclone
Not sure what model twin you have, I've been...

Not sure what model twin you have, I've been researching one for my camaro. McLoed RST & RXT do not use LS3 flywheel. They use LS1 flywheel out they have their own flywheel as well. Something about...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 02-21-2017, 05:29 PM
Replies: 25
Views: 9,296
Posted By SSyclone
I see your car is a manual, let me say from...

I see your car is a manual, let me say from experience the 3.91s are incredible. You will love your car all over again. Unless of course you throw a supercharger on it, then it's a handful. But...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 02-21-2017, 05:05 PM
Replies: 15
Views: 2,371
Posted By SSyclone
I have talked to a friend about McLeod I was told...

I have talked to a friend about McLeod I was told I would not be happy with the RST Twin but the RXT would probably handle the job.

I would still consider that but my main concern is the actual...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 02-20-2017, 07:33 PM
Replies: 15
Views: 2,371
Posted By SSyclone
In search of CLUTCH ?

I find myself in the market for a new clutch. I've read & read but haven't yet decided. I have to have a clutch that will hold what's going through it.

LSA with 2.5 pulley, cam, exhaust, etc....
Forum: Forced Induction - V8 02-01-2017, 07:38 PM
Replies: 9
Views: 1,198
Posted By SSyclone
My clutch let loose about 1 hour after tuning the...

My clutch let loose about 1 hour after tuning the car after adding LSA supercharger. I can drive normally still 1st 2nd 3rd are ok but 4th gear under hard power and it just let's loose and his the...
Showing results 1 to 30 of 60
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -5. The time now is 02:44 AM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.