Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
TireRack
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 500
Search took 0.05 seconds.
Search: Posts Made By: '10CamaroDude
Forum: 5th Gen Camaro SS LS LT General Discussions 08-27-2020, 04:39 AM
Replies: 9
Views: 3,694
Posted By '10CamaroDude
They can buy it back, and have to if the problem...

They can buy it back, and have to if the problem isn't fixed. You have
so many days to return a vehicle, and since it started the day he went
home, they know about it, it's documented. When I...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-26-2020, 02:48 PM
Replies: 8
Views: 2,164
Posted By '10CamaroDude
So, you do not know how to use a test-light, to...

So, you do not know how to use a test-light, to find which grey wire has power when
you open the doors? That's the purpose of having the PROBE. Then he says when
you (YOU), find the correct one,...
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 08-25-2020, 05:08 PM
Replies: 25
Views: 7,924
Posted By '10CamaroDude
The knuckle isn't the problem, it's the bushings....

The knuckle isn't the problem, it's the bushings. They can be pressed out and
new ones put in. I have a set of polys for the knuckle side of the UCA. The
knuckle is a sold piece of aluminum,...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-25-2020, 05:21 AM
Replies: 8
Views: 2,164
Posted By '10CamaroDude
It clearly says connect to the GREY wire @1:33.

It clearly says connect to the GREY wire @1:33.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 08-25-2020, 05:20 AM
Replies: 51
Views: 6,918
Posted By '10CamaroDude
Part# 92139142

Part# 92139142
Forum: Suspension / Chassis / Brakes 08-24-2020, 05:19 PM
Replies: 2
Views: 795
Posted By '10CamaroDude
What is the difference between the 1LE and ZL1...

What is the difference between the 1LE and ZL1 bars? I have a ~5 mile take off
rear sway-bar and the links from a 1LE. I can't use them unless I change to Brembo
brakes. I have a front with...
Forum: V6 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 08-24-2020, 03:32 PM
Replies: 16
Views: 3,214
Posted By '10CamaroDude
I am going to ground or B+ one pin, then run the...

I am going to ground or B+ one pin, then run the other pin to the coil side of
the vacuum pump relay. So, when it trips with low vacuum, it will latch
the relay and turn the pump on. Not sure...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-24-2020, 03:26 PM
Replies: 13
Views: 2,748
Posted By '10CamaroDude
Once you drive the car, all that ABS and TCS...

Once you drive the car, all that ABS and TCS should go away, that's what
happens when you disconnect the battery. You have to drive the car to
turn all that off. Just working on mine, and...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-24-2020, 03:11 PM
Replies: 11
Views: 2,617
Posted By '10CamaroDude
Just went through that, but we were able to get...

Just went through that, but we were able to get it out. We had to angle the
toe-rod, push on it while yanking on the bolt. IT did come out, and went
back in the same way. I got under it, and...
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 08-24-2020, 03:03 PM
Replies: 25
Views: 7,924
Posted By '10CamaroDude
As long as you do not loosen any the bracket side...

As long as you do not loosen any the bracket side bolts on the UCA, LCA, TOE, or
TRAILING arms, you should not have to worry about having to get it aligned. The
major ones being the TOE and LCA...
Forum: Tuning / Diagnostics -- engine and transmission 08-24-2020, 02:52 PM
Replies: 7
Views: 6,778
Posted By '10CamaroDude
http://gvperformance.com/images/2010%20pictures/ma...

http://gvperformance.com/images/2010%20pictures/mafconnector.gif
https://kvisit.com/Qg/1K0B (https://kvisit.com/Qg/1K0B)
All of engine performance diagrams 1-6, MAF is on Page 5.
Forum: 5th Gen Camaro SS LS LT General Discussions 08-24-2020, 03:41 AM
Replies: 14
Views: 5,333
Posted By '10CamaroDude
I removed my 2ndary cats, and I get a stronger...

I removed my 2ndary cats, and I get a stronger smell, but not FUEL. If you smell
fuel in your exhaust, then you have a problem. Modern engines with MPFI and DI do
not just dump fuel in like a...
Forum: Off-topic Discussions 08-24-2020, 01:38 AM
Replies: 22
Views: 6,429
Posted By '10CamaroDude
"One cries because one is sad. For example, I cry...

"One cries because one is sad. For example, I cry because others are stupid, and that
makes me sad."
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 08-24-2020, 01:29 AM
Replies: 25
Views: 7,924
Posted By '10CamaroDude
Brake Caliper Bracket Bolt - Rear (L99, LS3) 40...

Brake Caliper Bracket Bolt - Rear (L99, LS3) 40 N.m + 90 degrees or 30 lb ft + 90 degrees.
Brake Caliper Guide Pin Bolt - Rear 27 N.m or 20 lb ft
Brake Hose Fitting Bolt 40 N.m or 30 lb ft
Brake...
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 08-24-2020, 01:21 AM
Replies: 16
Views: 3,427
Posted By '10CamaroDude
Mine does it randomly. I will lose the left two...

Mine does it randomly. I will lose the left two tires, to dashes. Then the front
left, then the right rear. Now they're all reading again. That usually means the
TPMS sensors in the wheels...
Forum: V6 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 08-24-2020, 01:14 AM
Replies: 16
Views: 3,214
Posted By '10CamaroDude
I am still waiting to see when I can get those...

I am still waiting to see when I can get those valve covers off ya...
Would need all the bolts with the grommets on them too.
Coils all worked fine, car runs like a champ man.

Too bad I can't do...
Forum: Tuning / Diagnostics -- engine and transmission 08-24-2020, 01:10 AM
Replies: 7
Views: 6,778
Posted By '10CamaroDude
Yeah, but that does not tell you what each...

Yeah, but that does not tell you what each circuit in the MAF is.

L99/LS3:
Pin - Wire - Circuit- Function
A - 0.5 - YE - 492 -MAF Sensor Signal
B - 0.5 - BK/WH - 451- Ground
C - 0.5 - PK -...
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 08-23-2020, 03:30 PM
Replies: 25
Views: 7,924
Posted By '10CamaroDude
None of that is model specific. The bolts to not...

None of that is model specific. The bolts to not clamp the bushings in place, they
clamp the sleeve in place. Does not matter what the bushing is, or is made of, the
clamping force has to be the...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-23-2020, 03:30 AM
Replies: 1
Views: 942
Posted By '10CamaroDude
Remove the cover from the under-hood relay...

Remove the cover from the under-hood relay center. Read the diagram on top
underside of the cover which shows the location of the fuel pump relay inside
the relay center.
Forum: 5th Gen Camaro SS LS LT General Discussions 08-23-2020, 03:21 AM
Replies: 26
Views: 10,209
Posted By '10CamaroDude
If you get MOOG wheel bearings you're fine. ...

If you get MOOG wheel bearings you're fine. Their "house brand" do not hold up.
I bought "Driveworks" bearings for my mustang, they failed in three weeks. I put
MOOG ones on, they've held up.
...
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 08-23-2020, 03:12 AM
Replies: 25
Views: 7,924
Posted By '10CamaroDude
All the bolts need to be FINAL torqued at ride...

All the bolts need to be FINAL torqued at ride height. You can tighten them up, then
the car has to go to ride height for final torque. I just did all mine back there, and
to be honest, I didn't...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-22-2020, 06:57 PM
Replies: 26
Views: 10,209
Posted By '10CamaroDude
You can use ANY one of them up front. The...

You can use ANY one of them up front. The fitment detail has SS in there, so
they have to be the same where the three bolts line up to fasten the bearing
to the knuckle. A drop down on another...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-22-2020, 04:12 AM
Replies: 18
Views: 4,542
Posted By '10CamaroDude
It's actually 100% easier to change the whole...

It's actually 100% easier to change the whole unit, rather than taking it out,
taking it apart, and changing the ring and pinion gears, bearings, setting preload, and
spacing, putting it back...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-22-2020, 04:01 AM
Replies: 2
Views: 985
Posted By '10CamaroDude
They'd have to be some cheap-ass spacers to cause...

They'd have to be some cheap-ass spacers to cause wheel shake due to them
not being balanced. That would be like having rotors that were not balanced.

Tires are never perfect. You pushing them...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-22-2020, 03:52 AM
Replies: 18
Views: 4,542
Posted By '10CamaroDude
A howl or whine during acceleration over a small...

A howl or whine during acceleration over a small or large speed range is
usually caused by worn or burned ring and pinion gears or improper gear set
up.

Rumbling or whirring at speeds over...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-22-2020, 03:39 AM
Replies: 26
Views: 10,209
Posted By '10CamaroDude
You should do both, regardless. I had one rear...

You should do both, regardless. I had one rear one that was bad, I just
did both. My fronts were not bad, but I replaced them anyway.


I got FAG/SKF Bearings, they're lifetime warranted, and...
Forum: Camaro DIY & HOW-TO instructions & discussions 08-21-2020, 07:35 PM
Replies: 3
Views: 1,490
Posted By '10CamaroDude
That one from Amazon, I had one. It worked well...

That one from Amazon, I had one. It worked well for a while, but it eventually
broke. They're cheaper on eBay too. I used it for replacing most of my push in
fasteners on my mustang with nice...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-21-2020, 07:23 PM
Replies: 26
Views: 10,209
Posted By '10CamaroDude
The wheel bearings are the same, you just can't...

The wheel bearings are the same, you just can't use the V6 automatic in back. Any
SS, or V6 manual, you can, they're all the same. You use the same ones up front, but
I would use the V6 ones up...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-21-2020, 07:20 PM
Replies: 12
Views: 3,399
Posted By '10CamaroDude
This will also allow toxic air from the engine...

This will also allow toxic air from the engine compartment to get into the
cabin when you have the heat or A/C on. So,if you have any oil burning on
the engine, exhaust leaks, you'll smell it.
...
Forum: Exterior Parts & Accessories 08-21-2020, 12:32 AM
Replies: 7
Views: 3,286
Posted By '10CamaroDude
The coolant overflow reservoir cap is supposed to...

The coolant overflow reservoir cap is supposed to have the level ribbon on it, that long
thin plastic tape-worm type deal that you use to check the level.
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 01:59 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.