Quote:
Originally Posted by W.E.G.
I actually just read your post more closely.
My mind narrowly-focused on the hydraulic system, so I posted the torque specs for the hydraulic fittings.
I think maybe you asking for the torque specs for the installation of the rotor T-30 Torx screw, or perhaps the specs for the caliper-to-knuckle?
The spec for the Torx screw is 10 NM / 89 inch/lb
The spec for the FRONT caliper bracket is 60 NM / 44 foot/lb PLUS 90 DEGREES.
The spec for the rear caliper bracket is 40 NM / 30 foot/lb PLUS 90 DEGREES.
The spec for the caliper guide pins is 27 NM / 20 foot/lb .
|
Dear WEG
Despite my language barrier, you figured out my needs.
Definitly was the bracket specs.
Tank's again.
Olympio
Enviado de meu Moto X Play usando Tapatalk