I ran the "track" deflectors, they had bugs on the lower section (indicating they are scooping up air). I pushed the pads to a bit thinner than I normally do, the rotors did not crack. Funny thing though, the outer surface has a slight blue tint to it and the inner looks "normal"
Question for more experienced gurus: Is this because the inner surface gets more cooling than the outer surface? The outer surface cooling air has to pass between both surfaces and doesn't have as much of a cooling effect from the air???
EDIT: cudos out to MACH83 for the tip regarding orientation of the speed sensor wire. Outstanding, thank you sir!
http://www.camaro5.com/forums/showpo...8&postcount=34