|
Z28 rear upper outer bushing advice
Overhauling a large portion of the rear suspension in the next week or so and looking for some advice on changing these. I'm not planning on dropping the cradle(not upgrading subframe mounts) but will have most of the rear suspension out of the car so I should have some room in the wheel wells to move around. I know I had seen a post once about getting to these bushings but can't for the life of me find it again. Something about a long arm angled wrench if I remember correctly.
Anyway, any advice on tools or methods to get at these guys is greatly appreciated!
__________________
491 hp/438 tq
LS3 Conversion | Comp Cam Custom Grind | Mast Heads | Comp Cam Push Rods | LS7 Timing Chain | 180 Thermostat | Ported Intake | Ported TB | SLP UDP | K & N CAI | Custom 3800 Stall Converter | Aluminum 1 Piece Driveshaft | Kooks 1 7/8" LTH | High Flow Cats | ARH 3" Exhaust | ARH Mufflers | Eibach Lowering Springs | BMR Floor Brace Subframe Connectors with Tunnel Brace | BMR Moly Lower Rear Control Arms | Oracle LED Halo Kit
|