[Dragonman]

Sorry the pictures in previous post are so poorly focused. Old S4 was used for almost all of the pictures and videos in this thread. The below pics should be in order of the paragraphs as numbered. I reckon the only way to insert the pics between them is to get them hosted somewhere and use url links.

1&2. Everything out on the bench and ready for install after I brought the car back from it's spa day getting polished and ceramic coated.

3. Pre-removal of necessary panels

4. Post panel removal and after feeding cables behind AC duct.

5&6. Pod in place and cable ran. Had one helluva time getting the cable run through that 13/32 hole. Had to "ream" it a couple times and the external sheathing just did not want to slide. It isn't shown but I used about half the putty supplied with the pod to seal off the wire hole in the pod. As tight as the cable is in the hole in the defrost plenum I decided there just isn't enough room to bother sealing that off. If I notice problems with the window defrosting or defrogging I'll revisit that decision.

7. This is where I went a bit different than Don. Didn't seem to be near enough room there for the coil so I took it all down under the dash and laid it up beside a big loom there. That white wire is no longer just hanging there now either. It runs power and ground for the UGR in the second post.

8. Final product in place.