|
The process to bleed out air pockets is difficult and time consuming on these, but if you have run real hot you may have warped a head.
First, with engine cold remove upper radiator hose and full as full as possible from it (just one end). Then fill coolant reservoir to the very top, nit the full mark. Watch with cap off and it will settle and add more (make sure you do not go over 50/50 mix on antifreeze! The more antifreeze, the less effective heat transfer) each time. Then once it is no longer going down, you want to start and let warm up with cap off coolant tank. Turn off and replace cap and let cool. This will pull in more coolant as air pockets "burp" out. Open reservoir and fill again and repeat. But, you may have a head gasket issue if it has gotten too hot.
Good luck!
|