Finally installed the replacement wire harness for the AEM wideband. I did do a powerup test and it worked -- strange how I could 'test' for power but, the wideband did not run on the old one. Anyway, its working now. I did have a 'PITA' putting the nuts back on the hold down. I decided to use a spark plug tool and it worked perfectly:
This gave me the length and grip I needed to put these back on.
Now that I have that finished, I'll need to clean the ac pulley as there is a small 'screech' when I start the AC -- I'm sure there is some residue on the pulley as I can feel the water wetter on the ac pulley (some hot water and maybe some brake kleen and that should do it).
Gonna clean her up and drive it a bit before I start on the meth setup.
-Don