OK, so started tank prep for the ProMeth install. The first thing I did was drill out the required holes:
Sight Tube (1/2" holes drilled):
On the 'lower' hole, DRILL SLOWLY and don't go deep. Right below that area is the 'line' opening for the pump.
Low Fuel Level 3/4" hole saw:
On the Low Level hole, I used a 3/4 hole saw and, I made sure it cleared the shelf in the tank. You'll see where the hole is in relation to the angled relief...
After drilling, wash the tank out and make sure you have all the drill chips out of the tank.
Once I did that, I installed the sight tube. For these I used Dawn to ease install:
Grommets:
Inserts:
Tube, spring clamp, level ball:
Trimmed to fit and clamped:
Low Level indicator:
Next, I'll need to clear out the trunk, remove the rear seat then, wire and line.
-Don