Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post - IT LIVES! My Z/LE ZL1 + 1LE + 2SS = Z/LE ;o) LSA SC [COTW 2/09/15]

hammdo · 08-21-2018, 01:43 PM

Because I'm using the AEM Controller with the V1 Low Level Sensor, it requires the sensor be flipped 180°:

This is due to the AEM controller normally using a 'V2' resistance sensor -- SO remember that if you're using the V1 low level sensor (both wires are black) with AEM.

Also, when the controller starts up, it will flash green once and then 'dimly' light the LED -- this is normal and does not mean the pump is running -- just the unit is operating. 1 flash meaning in controller is in mode setting 1 (MAP 0-5V)

I called AEM, spoke with Matt in tech support -- he confirmed the above for me...

So, I just need to install the remote LED, THEN the nozzles!

-Don

08-21-2018, 01:43 PM	#2179
hammdo 'It's an experiment' Drives: [COTW 2/09/15] '11 GPI LSA SC Z/LE Join Date: May 2014 Location: Dallas TX Posts: 8,709 View My Garage	LSA ProMeth Setup cont. Because I'm using the AEM Controller with the V1 Low Level Sensor, it requires the sensor be flipped 180°: This is due to the AEM controller normally using a 'V2' resistance sensor -- SO remember that if you're using the V1 low level sensor (both wires are black) with AEM. Also, when the controller starts up, it will flash green once and then 'dimly' light the LED -- this is normal and does not mean the pump is running -- just the unit is operating. 1 flash meaning in controller is in mode setting 1 (MAP 0-5V) I called AEM, spoke with Matt in tech support -- he confirmed the above for me... So, I just need to install the remote LED, THEN the nozzles! -Don __________________ 747 RWHP 794 RWTQ "Horsepower sells cars, torque wins races." - Enzo Ferrari See My Build: http://www.camaro5.com/forums/showthread.php?t=385577 Last edited by hammdo; 08-26-2018 at 08:36 PM.