So, next was to put the new brick in and the manifold. I had to remove the old o-rings, clean them up, lube them with AGS Radiator Hose grease. I then set the brick in with only the back 2 bolts in -- this allows the brick to 'slide' as I setup the manifold.
Once I have the manifold started, I can then bolt down the manifold -- BTW, you WILL need to use blue loctite on the bolts.
After all slid together, I installed the other 2 front brick bolts and then torqued all to 89 in lbs:
Now the temp sensor and MAP:
Next will be the nozzles and fitting -- I will need to trim the Solid SS lines as they are currently 10" center to center -- I have a Ridgid SS tube cutter for that!
I'll give the lid a final cleaning then do the nozzle kit...
-Don