Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post - IT LIVES! My Z/LE ZL1 + 1LE + 2SS = Z/LE ;o) LSA SC [COTW 2/09/15]

hammdo · 08-25-2018, 05:22 PM

Lots of goodies today. Started on the nozzle install and setup.

First, Teflon taping 'small' items is a pain but, anything that is NPT, I taped it. So, here are the nozzles installed, I installed the nozzle until they were 'flush' with inside:

Nozzles:

Next, I cut the lines to fit -- notice I am 3 'ribs' from the end -- that is in keeping with the pics from ProMeth. Also I used a bit to 'clean' the cuts and make a nice smooth transition for the compression fittings:

I cut the tubes so they lined up (I cut 1 tube 1 1/8" and the other tube 1"). The way I cut the tubes lined up nicely.

Left side and the rest 'fitted' in place:

Next, I'm going to 'trial' fit the lid, set everything in place (tighten up) then, do a test of the nozzles!

After the test (which I'll video), I'll then do one more cleaning of everything, install the new gaskets, then button this puppy up!

-Don

08-25-2018, 05:22 PM	#2191
hammdo 'It's an experiment' Drives: [COTW 2/09/15] '11 GPI LSA SC Z/LE Join Date: May 2014 Location: Dallas TX Posts: 8,709 View My Garage	LSA ProMeth Setup ZL1 Lid cont. Lots of goodies today. Started on the nozzle install and setup. First, Teflon taping 'small' items is a pain but, anything that is NPT, I taped it. So, here are the nozzles installed, I installed the nozzle until they were 'flush' with inside: Nozzles: Next, I cut the lines to fit -- notice I am 3 'ribs' from the end -- that is in keeping with the pics from ProMeth. Also I used a bit to 'clean' the cuts and make a nice smooth transition for the compression fittings: I cut the tubes so they lined up (I cut 1 tube 1 1/8" and the other tube 1"). The way I cut the tubes lined up nicely. Left side and the rest 'fitted' in place: Next, I'm going to 'trial' fit the lid, set everything in place (tighten up) then, do a test of the nozzles! After the test (which I'll video), I'll then do one more cleaning of everything, install the new gaskets, then button this puppy up! -Don __________________ 747 RWHP 794 RWTQ "Horsepower sells cars, torque wins races." - Enzo Ferrari See My Build: http://www.camaro5.com/forums/showthread.php?t=385577 Last edited by hammdo; 08-25-2018 at 10:53 PM.