Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post - How would this backup camera be installed?

jmhenry5150 · 03-21-2019, 11:55 AM

I just purchased this:

https://www.amazon.com/gp/product/B07H852D49

And now after looking at it - I am not too sure on how the install will go...

The design looks like you would have to drill a hole above the license plate and then get behind there to screw in a nut to tighten it down.

I took off the back plastic siding in the trunk and it looks like it's solid metal and I would have to drill a hole to gain access?

I MIGHT be able to stick my fingers in through the license plate lights? But I don't think I would be able to get it tightened down very well?

Ideas?

03-21-2019, 11:55 AM	#1
jmhenry5150 2011 Camaro Newbie Drives: 2011 Camaro 2SS (With RS package) Join Date: Dec 2010 Location: Dallas, Texas Posts: 120	How would this backup camera be installed? I just purchased this: https://www.amazon.com/gp/product/B07H852D49 And now after looking at it - I am not too sure on how the install will go... The design looks like you would have to drill a hole above the license plate and then get behind there to screw in a nut to tighten it down. I took off the back plastic siding in the trunk and it looks like it's solid metal and I would have to drill a hole to gain access? I MIGHT be able to stick my fingers in through the license plate lights? But I don't think I would be able to get it tightened down very well? Ideas? __________________ - J. Michael Henry