|
There are two holes. One on bottom and one on top. The bottom hole use the existing screw to screw it on. Snug, now put pressure to the center of the guard so that way it will curve to the wheel well. Now line up the top hole to your desire (out, center or in) and mark center hole with a sharpie. Drill pilot hole and screw it on.
Make sure you use the mat side towards the driver and the glossy side to the wheel.
Make sure your pilot drill is smaller than screw.
Your choice you can use 3m double sticker but once you have it on it’s permanent.
I didn’t use 3m and it’s holding up just fine. Good luck mate. It’s really easy.
|