Quote:
Originally Posted by larry_g
Gap in time/mileage is fine, the computer just needs to see each of those conditions before it's considered a full cycle. It could be looking for something like a certain amount of fuel in the tank or a refill before completely resetting the evap codes.
|
Ok thank you. I know there is a pending/permanent code for the camshaft sensor. I had a cam swap and vvt was removed. I asked the tuner if this would prevent the evap from completing, he said no, hopefully that is true.
On the inspection report of shows the sensor as EGR/VVT, so I have no idea if that will ever complete but it shows on my scanner incomplete, along with evap system monitor. My tag expires today so I am getting frustrated.
I had to swap the tb last Tuesday because the tps went out as I was driving and engine went into limp mode. I swapped the tb and then cleared the codes. Probably a big mistake. But I honestly have no idea what the status of the monitors were prior.