Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post - DIY

kga10734 · 10-20-2009, 12:01 AM

Got mine done, but I still need to go back and glue the tube in place and do the fine sanding to the trim pieces. At least I have it working so far. Once I get the dash fine tuned, I'll start working on the doors. I may go ahead and put El wire in the doors as well.

The sanding is a bitch, but trying to get the El wire down the tubes is worse unless you had a trick to do it.

10-20-2009, 12:01 AM	#53
kga10734 Don't Feed the Troll Drives: 2010 Camaro 2LT/RS & 1999 Corvette Join Date: Jun 2009 Location: Montgomery, TX Posts: 774	Got mine done, but I still need to go back and glue the tube in place and do the fine sanding to the trim pieces. At least I have it working so far. Once I get the dash fine tuned, I'll start working on the doors. I may go ahead and put El wire in the doors as well. The sanding is a bitch, but trying to get the El wire down the tubes is worse unless you had a trick to do it.