[TheInfamouSS]

Step 5:

Now comes the fun part. We are ready to tap into the wires for the Clutch and Accelerator Pedal sensors. To access the wires we are going to want to remove the connections from each sensor. You have to depress the grey tab in the middle while pulling up at the same time to get the grey piece off. Once you do that you just push down in the middle and pull up and the connector should come right out. Practice on the Accelerator Pedal first because the clutch switch is a lot harder.

**Picture of the Clutch Switch Harness. Accelerator Pedal Harness is on top of the gas pedal, you can’t miss it.**

Once you get both connector harnesses removed you are now ready to run the BLUE and GREEN wires from your WOT Box. Determine how you are going to run the wires and cut them to length, then remove some of the protective wrap from the harness to make your splice. You are going to tap into the Yellow wire from the Clutch Switch Harness with the GREEN wire and the Light Blue wire from the Accelerator Pedal Harness with the BLUE wire from the WOT Box. When you are done: re-wrap the harness, connect the sensors and secure your wiring.

**Picture showing GREEN wire from WOT Box connected to yellow wire from clutch harness**

**[If you are pinning these wires to the ECU the GREEN wire from the WOT Box goes to the Yellow Cutch Switch wire pin X1-26 and the BLUE wire from the WOT Box goes to the Light Blue APP Sensor wire pin X1-32.]**