Been doing a lot of stuff over the last few months. Was looking at a LSA setup but started seeing some of those parts going on back order/hard to get. Ended up going with a Maggie Heartbeat, DSX aux pump, ID1050's, GPI SS3 PD cam & GPI ported heads.
So, started by getting the car sideways in the garage and lifted with the quick jacks
Last pic of what it looked like before getting started
Took the nose off.
Then tearing down the engine began.
Got the block out
Did the oil cooler delete while it was out
ICT Cooler bypass installed
New coolant plug installed
Flex fuel sensor installed
White wire goes into pin 40
Shot of the wire loom before pin 40 is in
Arrow showing white wire in place
__________________
2014 Camaro SS L99, Ashen Grey w/Black Leather - Build thread -
http://www.camaro5.com/forums/showthread.php?t=491561
Mods - GPI 416 w/Custom Grind Cam, Ported Heads & Tuned by Ben, Holley Dominator ECU, Mag Heartbeat, ZL1 Fuel Pump & DSX Aux Pump, NW 103 TB, FIC 1650's, Alky Meth, Circle D 3600 Triple Disc, Kooks Headers, Viking Coil Overs & all the BMR Goodies in the rear, Zl1 3.23 Diff, DSS Axles, Gulfcoast Driveshaft, Hendrix Offset Diff Bushings, AFE Solid Subframe Bushings, 875HP/843TQ 5FDP