|
Also, the gaskets on the bottom of the blower to the heads will be fine. Just reuse them too. Same for the lid to the blower.
The gasket inside the lid that goes between the brick and rotors can be a pain because when it's warm it will stretch. I suggest putting in the freezer for a bit to shrink it before installing the lid back on.
__________________
2014 ZL1 M6: Roto Fab Intake, LS3 TB, Long Tube Headers, NPP, Mild 2 Wild, JMS BAP, SMG aux pump, ID 1050X Injectors, DSX Flex Fuel Sensor, 10.5" DSX Lower Pulley, Killer Chiller, Tuned by Ted at JRE, Pedders XA Extreme coilovers, Mickey Thompson Street S/S on Weld S71s
|