03-16-2023, 10:17 PM
|
#13
|
|
Drag and Drive is Life
Drives: 2010 Camaro 2SS RS A6 LS3 Whipple
Join Date: Aug 2021
Location: TX
Posts: 143
|
Wiring diagram
Wish I had a wire diagram it would be so helpful at this point. Thanks
Quote:
Originally Posted by AGP Turbo
You done good so far. It's super frustrating the first time but a sharp learning curve. Pretty easy the second time.
Use Dynamat over the hole you just cut, on top of whatever metal door you make. You get a lot of pump noise and road noise up through that hole even when covered with sheet metal.
|
__________________
My build link... https://www.camaro5.com/forums/showt...4#post11077544
2010 2SS/RS/ Mods, Whipple, 1000cc injector, 102MM TB, Innovation West 10% OD pulley set up 8 rib, AGP twin 450 fuel system w flex on E85, CAI K&N, LT with OR Cats aka no catalytic converters, Coils and wires, 3" exhaust with mufflers, Oil catch can, 2015 ZL1 9.9 3.23 ratio, BMR upper Lower control arms, 15"conversion, BMR Anti Roll Bar 315/60/15 ET street slicks
1972 El Camino SS 565BBC 950HP, All TRZ suspension |
|
|