I was also able to finish installing underglow lights. Although, the kit included two long strips for the sides (which were perfect to go from wheel to wheel), the ones for the front and back were way too short (each about 20” long). I ended up buying a 100cm strip for the front, and used the two shorter ones in the rear. They are powered by the same switch for the ones I have under the hood and in the front grill, but they are connected to a separate Bluetooth controller so I can turn them off via their app.
For the install, I have the two small strips on the bottom of the trunk (directly below the battery/spare tire well). The sides run along the pinch rail (just behind where my ZL1 Addon lift pads are), and the front strip is towards the back (along where the air deflector used to be…I left mine off when I installed the front splitter). I used a bunch of mag daddy’s to secure the wires under the car and brought the sides/rear lights into the trunk using existing holes that were plugged from the factory. The front connection is on the passenger side (right near the harness for the front bumper). I then ran the wire through the passenger side firewall, through the raceway and under the backseat to the trunk.
With everything back together, I had plenty of time to give it a quick wash and head over to a local Cruise Night. Since I hung out in the parking lot after the show had ended, it got dark enough to be able to flip on the lights and see the full effect.
