Quote:
Originally Posted by KingLT1
you might try a metco valve cover breather with check valve and see if the leak goes away.
|
I ordered that yesterday. My valve covers have 2 vent spots on each cover. (Dsx covers) both front most vents are being used by the vented can.
I’m going to put the breather on the drivers side rear vent. Only place it will fit.
I just can’t see how it would need more venting since it’s already being vented on both covers into the can.
__________________
928rwhp - 93 | 1040rwhp/898rwrq - E65 SAE
LME 377 LT4 Short Block | Magnuson 2650 80mm upper w/13% lower (9.06) | DSX Lid & Valve Covers | CSP Custom Cam w/32% fuel lobe | CID Heads | NW 103mm TB | Roto Fab Big Gulp | CSP 2" Headers w/Green GESI Gen 2 Cats | Borla 3" Full Cat Back w/ S-Type| Mighty Mouse Wild Catch Can| Custom Holley Low side Fuel system| TooHigh PSI Port Injection w/Holley Controller | Forced Inductions Interchiller w/2 gallon fender tank | TK Performance built 10L90