|
Hey acammer, haha I really appreciate your response. If I rephrase a little. I actually love where the clutch pedal is at, very high!! I tested the car, every gear changes perfectly fine. I am actually going to check the point of engagement and get back to you!!
however the reason for my post is because I feel like my bearing is gonna wear faster if it is too close to the PP fingers meaning maybe there's too much preload on the fingers and the bearing. I now know the bearing it supposed to have constant pressure but it's just the fear of having the bearing wear out faster than what it is supposed too and not having the correct preload.
am I suppose to hear the bearing turning while in neutral/idle position? (slightly though?)
and what pedal stop did you use? and would it be compatible with the RAM slave? it could also be that I may have a bit more over traveling I fear. Im not sure, it is my first time changing the clutch on my car!!
|