|
Ok so the cel came back on. Note sure if this is a coincidence or not but the first time the light came on it was raining, drove it for 2 weeks and it was raining today again and it came back on. And this time I also had the service stabilitrak message appeared with the 3 lights but turned off within 10 secs.
Same 2 codes as before.
P0300 & P0357
The car seems to drive fine and not rough.
I’m assuming to just start off with swapping the coil and go from there?
If I swap 2 coils to see if it follows Would I just reset the light and wait till the cel comes back to read the codes?
|