Quote:
Originally Posted by SSE 4 2SS
I run a DSS 9", with a Strange center section and a Wavetrack diff.... DSS 1400 HP axles and I've thrashed on it for years running north of 2000 RWHP.... No issues....
As to the comments referencing the exhaust clearance, I also run dual 3.5 inch exhaust, in the tunnel with a 4" one piece driveshaft and the exhaust is routed in the factory location.... I'll stipulate, I removed some of the "foil" type heat shielding and the tunnel brace.... As hard as I run the lack of a tunnel brace has never been an issue....
|
I know this is now a 4 year old thread but curious as to what length axles you are running with that 9inch, have the same setup ready to go sitting in the garage but need axle length to get some ordered. Haven’t had the time to drop the current rear end and take measurements as that seems to be the only way to get axles for this particular rear and the particular unit is older than what they currently sell🥺