|
What are the steps for used when doing a bleed? I noticed it is easy to reintroduce air into the system if it is not done correctly. I have a remote bleed line on mine and perform bleeds by myself.
My steps ...
Make sure reservoir is full
place cover back on reservoir
Pump pedal several times and hold to floor while cracking bleed open slightly
hold pedal to floor and close bleed
repeat process until i have good fluid flow and good pedal.
I ran into issues when i let reservoir go to low and also by not holding pedal to floor before closing valve.
I also noticed it works better by just cracking bleed valve to ensure slow pressure release and also to close valve just before it stops flowing fluid, not after it stops flowing fluid.
|