Quote:
Originally Posted by mr_honez
Just tighten the top bolts down good and you'll be fine. Like I said earlier remember you are tightening them in to aluminum. You can torque the rest to spec.
|
What’s the easiest way? Just use the extensions with a 1/2” inch drive ratchet or something, to start off the bell housing bolts? I figured it would be a bad idea to try to start the threads of those bolts with the impact gun (1/2” in drive). I’m scared of potentially over-tightening into aluminum, but I definitely wanna get it a bit tighter than 37 ft/lb.