|
Hi Joe. Thanks for your reply. Your latest post was interesting ... or concerning ... the "alignment" marks on your shaft are 180 out from what the other guys are telling me. Oh boy ... that cast a lot of doubt on the correct setup??
I have the driveshaft back in my car ... and the exhaust too ... which was a PITA for me being that I don't have a lift and was doing it all on my back on the garage floor. I haven't driven the car yet as I'm still hooking everything up on the engine. Should be done tomorrow or the day after and then we'll take it for a test drive and see what happens. Thanks again Joe.
|