Good Morning Camaro fam!
It's been a minute since I've updated here. Been piling the miles on the new setup and she is running top notch.
I solved the vibration issues I was having. Finally found a shop the could road force balance my front tires proper.
Only one issue that I have left. Minor Oil control issue when in boost. Just purchased what I need to do to mitigate that issue and will update when I get around to installing those parts.
Now on to the good stuff...
Consolidated all the buttons/controls into an Auxbeam 6 gang button panel under the radio, providing a total of 8 separate functions.
Design, 3d printed parts, and labels are made by me. Pic is a bit misleading, 4 pack is visible from driver's perspective.
Button 1: Scavenge Pump OFF
Button 2: Water Pump OFF
Button 3: Split Function, On = Line Lock Enabled (Active by Left Steering wheel button) - Off = Boost Scramble Enable (Active by Left Steering wheel button)
Button 4: Split Function, On = 2 Step Enabled (Active by Right Steering wheel button) - Off = Anti Lag Enable (Active by Right Steering wheel button)
Button 5: Open Exhaust Valves
Button 6: Close Exhaust Valves
Moved AirLift display and boost controller to the Center Console. Added a few power ports and programming ports along with on/off for the Air system, and valve control for the tank drains.
Will probably reprint and cover in vinyl at a later date.
Made a back plane for the Driver side fuse area. Fuses, clutch switch, OBD2 stuff, boost gauge sensor and other misc...
Steering wheel buttons and Cleaned of A-pillar.
Relays and Auxbeam controller.
Had to get creative with this as space is limited. On the left is the a bank of 6 relays, fuse block(s) and 50amp breaker.
Yes, she was dirty!
Installed a Fumoto oil drain last oil change/health check. Clean bill of health!
And finally got that personalized plate...
Brian
