[BFxenon.com]

How-To: Install BFxenon HID Fog Lights

When installing BFxenon HID lights, for your safety, please remember to remove the battery terminal / positive lead to the battery before connecting any high voltage parts.

Step 1: Twist and pull to remove factory bulbs from the factory housing

*Step 2 and 3 are for the RS package equipped cars.
Step 2: Remove the black plastic surround, with a flat head screwdriver, by lifting up on plastic tabs.

Step 3: Remove the fog light housing from the bumper by squeezing the tabs and pushing them through the hole that secures them.



Step 4: Insert 5202 BFxenon HID bulbs directly into the housings (housings supplied in RS-Package kits) and secure them in place with the clips on the bulb. Make sure both sides clamp down

Step 5: Remove factory connection and attach the new lead provided



Step 6: Insert new lead into the ballast and connect the two leads on the ballast with the 5202 HID bulb

Step 7: Run the fog light switch into the cab.
*We ran the switch through the fender well and into the wire loom through the door. We had to add about 2’ of wire to accommodate the necessary length.
*You could also run it directly through the firewall by the brake master cylinder.


Step 8: Re-attach the positive battery connection and turn everything on. This is just to ensure everything lights up properly before you secure the ballasts and wires.

Step 9: Secure the HID ballast within the range of the connections so there is no stress on the bulb. Some recommended locations are; firewall, radiator mounting brace, front bumper brace, etc. (Some of these may not be the best option for every vehicle)

Step 10: Secure all the loose wiring away from any moving parts and out of the way of extreme heat.

Step 11: Enjoy your BFxenon HID headlights!




For more information or suggestions on how to make these instructions better, please contact: Sales@BFxenon.com