|
Ok - here is where we are now.
We took the infinity Kappa's apart and wired the high and low wires directly to the speaker - the low end sounds like sh*t! and the highs aren't even that great.
So now my question is this - if I just want to add a 4 channel amp and power the front and rear speakers through it - where do I tap in to get the signal to do it?
The whole "high and low" signal wires on the rear is what is messing me up.
Do I need to use something like the 'Cleansweep" to merge the signals back together and then take that to the amp?
BTW - the sub wolfer works fine and we just tapped into the preamp signal going to the factory amp in the trunk.
Any help appreciated!
Todd
|