Quote:
Originally Posted by Dano
I have searched the forum and can't find any who has asked before so here goes. Exhaust is the 16482 2.5" Magnaflow Comp. Series.
Are the D/S & P/S mid pipes supposed to touch the cross member support that goes on near the end of the heatshield? I think I may have installed the muffler sub assembly upside down. The directions were not very clear.
The car has a drone while curising around 65-72 MPH, it is always there while in 6th gear between 1800-2100 RPM. This is right at the crusing speed.
So just wondering if anyone else with this set up has any drone there and if there pipes touch that cross member support.
Thanks for any help or advice you may have.
|
I have the Magnaflow street and I know what you're talking about as far as the exhaust making contact with the crossmember. My Magnaflow street also made contact with the crossmember (caused a bad vibration noise). We had to re-adjust everything so that the exhaust wouldn't make contact anymore (1/2'' clearance).
You can also purchase a new crossmember that provides more clearance. There's a couple companies that sell them. If you can't get the exhaust away from the crossmember, that might be something to look into.