Quote:
Originally Posted by HaveBlue
Installation is the number one biggest problem. (on any electrical item). These tips are from my MSD days, but apply to any install.
Use a wire gaugesize one up from stock for any splice.
Don't use butt connectors, solder and heat shrink it. And the biggy, GROUND, GROUND, GROUND.
Did I mention that the GROUND is the No.1 most important electrical connection? Bad ground = unit failure.
|
but my lost of power was the stock setup from factory.
but agreed always solder..
ground def up there with problems.. people do power wire good and solder then just put ground wire under a nut LoL